Hasbro My Little Pony Walking Sweet Steps User manual

™
Walking Sweet Steps™
Thank you for purchasing this My Little Pony® toy! For maximum play
value, please read and follow instructions carefully.
AGES 3+
61984
Includes pony figure, walker, rattle, sippy cup, and brush. Pony and walker contain magnets.
Note: Walker is
designed to work
with included
pony only.







All manuals and user guides at all-guides.com
all-guides.com

TO PLAY
RESET
SWEET STEPS is a plush, cuddly pony you can play with in and out of
her walker!
Clap your hands or shake the included rattle in front of the pony and
pony will move forward and backward in random directions. As she does,
her head will also move from side to side. When pony stops moving,
clap or shake rattle again to
reactivate. While seated in
walker, pony will laugh or say
any one of 9 phrases, such
as “This is fun!” (Pony will not
speak when out of walker.)
After about 30 seconds of
non-activation, toy will go into
sleep mode and LED light will
turn off. To reactivate, press the
heart button.
Place pony securely in the
walker; make sure the pony’s
legs are placed all the way
down into the walker and
positioned as shown with
the feet on either side of the
center bar. Slide ON/OFF
switch to the “ON” position,
then press the heart-shaped
RESET button. When LED
light comes on, walker is
ready for play.
Please note
In order for toy to function:
• LED button must be on
• Included pony must be seated securely in walker
• Walker must be on floor
Toy may not function if used with any other pony figure. If toy is lifted off the floor
while in play, activation will shut off within 1⁄2 second. Place on floor and clap or
shake rattle to reactivate.
Note: Walker is designed to perform best on hard, smooth floors; may not function
on other surfaces.
Note: The toy uses battery power whenever switch is in the “ON” position. To
conserve batteries, move switch to “OFF” position when you’re not playing with
SWEET STEPS.
All manuals and user guides at all-guides.com

TO REPLACE BATTERIES
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be
sure to insert them correctly by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries, or standard (carbon-zinc) with
alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a
long time.
5. Do not short-circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference,
move it away from other electrical equipment. Reset (switching off and back
on again or removing and re-inserting batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of
batteries. Always remove from the product before recharging. Recharge
batteries under adult supervision. DO NOT RECHARGE OTHER TYPES
OF BATTERIES.
CAUTION: TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and always follow the toy
and battery manufacturers’ instructions;
2. Do not mix old batteries and new batteries or alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
Use a Phillips/cross head
screwdriver to loosen screw in
battery compartment door (screw
remains attached to door). Remove
door and remove old batteries.
Insert 4 x 1.5V fresh “C”/LR14 size
alkaline batteries. Replace door
and tighten screw.
All manuals and user guides at all-guides.com

© 2005 Hasbro. All Rights Reserved.
TM & ® denote U.S. Trademarks.
61984 Asst. PN 6547920000
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy, and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
MyLittlePony.com
MyLittlePony.com
Visit
All manuals and user guides at all-guides.com