HAUL MASTER 96279 Parts list manual

12V EMERGENCY VEHICLE
REVOLVING LIGHT
Model 96279
ASSEMBLY AND OPERATION INSTRUCTIONS
Diagrams within this manual may not be drawn proportionally.
Due to continuing improvements, actual product may differ slightly from the product described herein.
Distributed exclusively by Harbor Freight Tools®.
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our website at: http://www.harborfreight.com
Read this material before using this product.
Failure to do so can result in serious injury.
SAVE THIS MANUAL.
Copyright©2007 by Harbor Freight Tools®. All rights reserved. No portion of this
manual or any artwork contained herein may be reproduced in any shape or form
without the express written consent of Harbor Freight Tools.
For technical questions or replacement parts, please call 1-800-444-3353.

Page 2SKU 96279 For technical questions, please call 1-800-444-3353.
SPECIFICATIONS
Power Source 12V DC
Material Polycarbonate lens, magnetic base
Magnetic Base Diameter 2.76”
Bulb Type 12V10 Krypton
Rubber Base 1/2” tear drop shape
Flashes Per Minute 90-120
Power Cord Stretchable to 29-1/2” Long
Save This Manual
You will need this manual for the safety warnings and precautions, assembly, oper-
ating, inspection, maintenance and cleaning procedures, parts list and assembly diagram.
Keep your invoice with this manual. Write the invoice number on the inside of the front
cover. Write the product’s serial number in the back of the manual near the assembly dia-
gram, or write month and year of purchase if product has no number. Keep this manual
and invoice in a safe and dry place for future reference.
GENERAL SAFETY RULES
WARNING!
READ AND UNDERSTAND ALL INSTRUCTIONS
Failure to follow all instructions listed below may result in
electric shock, fire, and/or serious injury.
SAVE THESE INSTRUCTIONS
Keep your work area clean and well lit.1. Cluttered benches and dark areas invite
accidents.
Do not use this product in rain or wet conditions.2. Water entering this product
will increase the risk of electric shock.
Stay alert. Watch what you are doing, and use common sense when using this3.
product. Do not use this product while tired or under the influence of drugs,
alcohol, or medication. A moment of inattention while operating this product may
result in serious personal injury.
Keep out of the reach of any children. A responsible adult should be present if4.
children are in the area while the Revolving Emergency Light is being used.
Do not use the Revolving Emergency Light if the On/Off Switch does not turn5.
it on or off. Any product that cannot be controlled with the On/Off Switch is dan-
gerous and must be replaced.
REV 07K

Page 3SKU 96279 For technical questions, please call 1-800-444-3353.
Disconnect the Power Cord Plug from the power source before making any6.
adjustments, changing accessories, or storing the Revolving Emergency Light.
Always unplug the Revolving Emergency Light from its electrical outlet before
performing any inspection, maintenance, or cleaning procedures.
Store idle equipment.7. When not in use, make sure Revolving Emergency Light
is cool to the touch and then store in a dry location to inhibit rust. Store an idle
Revolving Emergency Light out of reach of children and other untrained persons.
This product is dangerous in the hands of untrained users.
Check for breakage of parts, and any other condition that may affect the Re-8.
volving Emergency Light operation. If damaged, have it serviced before using.
Many accidents are caused by poorly maintained products.
Tool service must be performed only by qualified repair personnel.9. Service or
maintenance performed by unqualified personnel could result in a risk of injury.
When servicing a tool, use only identical replacement parts. Follow instruc-10.
tions in the “Inspection, Maintenance, And Cleaning” section of this manual.
Use of unauthorized parts or failure to follow maintenance instructions may create
a risk of electric shock or injury. The fuse in this unit must only be replaced with
another Fuse of the same type.
Maintain labels and nameplates on the tool.11. These carry important information.
If unreadable or missing, contact Harbor Freight Tools for a replacement.
Never leave the Revolving Emergency Light unattended when it is plugged12.
in. Turn off the Revolving Emergency Light, and unplug it from its electrical outlet
before leaving.
Do not allow the Revolving Emergency Light to be exposed to fire or high heat13.
as this may result in an explosion.
Only plug into a 12 V DC Cigarette Lighter Adapter receptacle.14.
Do not deplete the vehicle battery.15. If possible, only use this product when the
vehicle’s engine is running. If the engine is not running, do not use the Light for
and extended period of time.
Make sure the vehicle lighter socket has a minimum capacity of 12 amps.16. Do
not use a socket extension or pigtail to operate this Light.
Follow all local and state laws regarding vehicles and lighting systems for17.
vehicles, check with your local Department of MotorVehicles or police station
for guidelines.
The Revolving Emergency Light is not waterproof.18. Do not submerge the Light,
or use it in extremely wet conditions.

Page 4SKU 96279 For technical questions, please call 1-800-444-3353.
Be careful to avoid scratching or damaging the surface of the vehicle with the19.
Revolving Emergency Light. Harbor Freight Tools is not responsible for any
damage to the vehicle, its exterior or interior paint or surfaces which result
from use of the Revolving Emergency Light.
People with pacemakers should consult their physician(s) before using this20.
product. Electromagnetic fields in close proximity to a heart pacemaker could
cause interference to or failure of the pacemaker.
UNPACKING
When unpacking, check to make sure that the item is intact and undamaged. If any
parts are missing or broken, please call Harbor Freight Tools at the number shown on the
cover of this manual as soon as possible.
ASSEMBLY INSTRUCTIONS
1. WARNING! Make sure the On/Off Switch of the Revolving Emergency Light is
in its “OFF” position and that it is unplugged from its electrical outlet before instal-
lation or replacing a fuse or bulb.
Your Revolving Emergency Light comes completely assembled. Instructions on2.
replacing the Fuse and installing the Revolving Emergency Light are outlined on
the following pages.
Replacing the Fuse
If the Revolving Emergency Light fails to operate when plugged into the cigarette1.
lighter adapter receptacle, the Fuse should be changed - see Figure 1.
REV 07K
Cover
Fuse

Page 5SKU 96279 For technical questions, please call 1-800-444-3353.
Screws (7)
Base (6)
Cover (1)
Figure 2
2. Unscrew each of the Screws (7) from the Base (6). Remove the Cover (1) from the
Base (6)- see Figure 2.
Separate both sides of the Fuse Cover (16) and pull out the Fuse-see Figure 1.3.
Replace with a new Fuse. Do not replace with a different size fuse, as this may4.
result in excessive heat and damage to the product. The new fuse must be of the
same size and amperage.
Replacing the Bulb
socket
Bulb (3)
Figure 3
1. Unscrew each of the Screws (7) from the Base (6). Remove the Cover (1) from
the Base (6).
Make certain to wear leather work gloves when replacing the Bulb. Gently but firmly2.
grasp the Bulb (3). Applying slight pressure, push down on the Bulb (3) and twist
it so that it slides out of the socket. Do not force the Bulb. If it does not move or
come out of the socket with light pressure, have it replaced by a qualified service
technician. Please refer to Figure 3.
REV 07K

Page 6SKU 96279 For technical questions, please call 1-800-444-3353.
Replace with a new Bulb. Press the Bulb into the socket so that the pin on the Bulb3.
slides into the socket groove. Twist until it is firmly in the socket.
OPERATION INSTRUCTIONS
The Revolving Emergency Light can be placed onto the vehicle as desired. The1.
Light has a magnetic base which will adhere to metal surfaces.
Make certain that there is sufficient length in the Power Cord to reach the Cigarette2.
lighter.
Plug the Cigarette Lighter Plug (17) into the lighter plug receptacle of your vehicle.3.
Leave it plugged in while using the Revolving Emergency Light from your vehicle.
Place the Revolving Emergency Light onto the top of your vehicle.4.
Use the On/Off Switch to turn the Revolving Emergency Light “ON”.5.
When the Revolving Emergency Light is not being used, turn “OFF” the Light, unplug6.
the Cigarette Lighter Plug from the lighter plug receptacle and remove the Light
from the top of your vehicle. Gently pull the Light off; do not slide it off. Sliding the
light off of your vehicle may result in damage to the paint and vehicle.
Do not leave the Revolving Emergency Light running if your leave the area.7.
INSPECTION, MAINTENANCE, AND CLEANING
1. WARNING! Make sure that the Revolving Emergency Light is in the “OFF” posi-
tion and that it is unplugged from its power source before performing any inspection,
maintenance, or cleaning procedures.
BEFORE EACH USE,2. inspect the general condition of the Light. Check for loose
screws, misalignment or binding of moving parts, cracked or broken parts, damaged
electrical wiring, and any other condition that may affect its safe operation. Do not
use damaged equipment.
Store the Revolving Emergency Light in a dry location out of direct sunlight. Keep3.
the Light out of the reach of children.
Clean with a soft cloth. Do not use flammable liquids or harsh detergents to clean4.
the Revolving Emergency Light. Do not submerge in fluid to clean.
REV 07K

Page 7SKU 96279 For technical questions, please call 1-800-444-3353.
PARTS LIST AND ASSEMBLY DIAGRAM
16
Part Description Q’ty
1Cover 1
2Reflector 1
3Bulb 1
4Big Gear 1
5Motor Stand 1
6Base 1
7Screw (M2.6*8) 4
8Magnet 1
9Small Gear 1
Part Description Q’ty
10 Label 1
11 Motor 1
12 Cord Fixer 2
13 Motor Screw (M2.3*4) 2
14 Screw (M2.5*20) 1
15 Resistor 1
16 Fuse / Fuse Cover 1
17 Cigarette Lighter Plug 1
17
3
REV 07K

Page 8SKU 96279 For technical questions, please call 1-800-444-3353.
LIMITED 90 DAY WARRANTY
Harbor Freight Tools Co. makes every effort to assure that its products meet high
quality and durability standards, and warrants to the original purchaser that this product
is free from defects in materials and workmanship for the period of 90 days from the date
of purchase. This warranty does not apply to damage due directly or indirectly, to misuse,
abuse, negligence or accidents, repairs or alterations outside our facilities, criminal activity,
improper installation, normal wear and tear, or to lack of maintenance.We shall in no event
be liable for death, injuries to persons or property, or for incidental, contingent, special
or consequential damages arising from the use of our product. Some states do not allow
the exclusion or limitation of incidental or consequential damages, so the above limitation
of exclusion may not apply to you. THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL
OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF
MERCHANTABILITY AND FITNESS.
To take advantage of this warranty, the product or part must be returned to us with
transportation charges prepaid. Proof of purchase date and an explanation of the com-
plaint must accompany the merchandise. If our inspection verifies the defect, we will either
repair or replace the product at our election or we may elect to refund the purchase price
if we cannot readily and quickly provide you with a replacement. We will return repaired
products at our expense, but if we determine there is no defect, or that the defect resulted
from causes not within the scope of our warranty, then you must bear the cost of returning
the product.
This warranty gives you specific legal rights and you may also have other rights
which vary from state to state.
3491 Mission Oaks Blvd. • PO Box 6009 • Camarillo, CA 93011 • [phone]
Note: Some parts are listed and shown for illustration purposes only, and are not available individually as
replacement parts.
REV 07K
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST
AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEI-
THER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION
OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED
TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED
TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS RE-
PLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECH-
NICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LI-
ABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT
OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTAL-
LATION OF REPLACEMENT PARTS THERETO.
PLEASE READ THE FOLLOWING CAREFULLY