Page 2SKU 98019 For technical questions, please call 1-800-444-3353.
ASSEMBLY INSTRUCTIONS
Read the ENTIRE INSTRUCTIONS
AND PRECAUTIONS section at the
beginning of this document including
all text under subheadings therein
before set up or use of this product.
Assembly
Slide the Hitch End of the Linker (1) (See1.
Figure 1) into the vehicle’s trailer hitch and
lock with a steel pin.
Install the square tube (2) to the upright part2.
of the Linker (1) and secure with a Screw (5),
Washer and Nut (6) (7), through the bottom
hole and the Hitch Pin (4) through the upper
hole. When the back hatch or tailgate has to
be accessed, pull the Hitch Pin (4) out and
swing the rack downward, pivoting at the bolt
directly below the Hitch Pin (4).
Slide the square end of the Bike Rack (3)3.
over the upper portion of the vertical tube (2).
Secure this with two Bolts (5), four Washers
(6) and two Nuts (7). It is recommended that
if you plan to carry only one bike, you put it in
the position closest to the vehicle.
Double check all nuts and bolts making sure4.
they are all tight.
This rack is designed to hold up to two bikes.5.
Place the rst one on the rack. Open the
Velcro straps and place the bicycle cross-bar
onto the holders. Close the straps over the
bike. Place the second bike facing in the op-
posite direction and secure it with the Velcro
straps as well.
The Thermoplastic Holders keep the bike(s)6.
in position, preventing them from sliding back
and forth causing damage. The straps keep
the bikes from bumping out of the holders.
PARTS LIST & ASSEMBLY
DIAGRAM
Part Description Qty.
1 Linker 1
2 Square 1
3 Bike Rack 1
4 Hitch Pin 1
5 Screw 3
6 Washer 6
7 Nut 3
1
2
6
3
7
4
5
Hitch
End
Figure 1
Record Serial Number Here:
Note: If product has no serial number, record
month and year of purchase instead.
Note: Some parts are listed and shown for illustra-
tion purposes only, and are not available
individually as replacement parts.
PLEASE READ THE FOLLOWING
CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS
PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM
IN THIS DOCUMENT AS A REFERENCE TOOL ONLY.
NEITHER THE MANUFACTURER OR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY OF ANY
KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED
TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT
HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF
THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS
AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN
BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT
BY THE BUYER. THE BUYER ASSUMES ALL RISK AND
LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO,
OR ARISING OUT OF HIS OR HER INSTALLATION OF
REPLACEMENT PARTS THERETO.
