Hay COPENHAGUE DEUX CPH250 User manual

COPENHAGUE DEUX
CPH250
By RONAN & ERWAN BOUROULLEC
> INSTRUCTIONS MANUAL <
H AY
L120 x W60 x H39 cm

> INTRODUCTION <
Copenhague Deux is a range of tables and benches
for compact spaces. The collection offers dining tables,
coffee tables and benches in different sizes.
The tabletop surface is made from a new laminate based
on Nanotechnology providing an extremely matt
surface with a soft touch that is anti-fingerprint and
easily cleaned.

> CARE AND MAINTENANCE <
LACQUERED OR STAINED WOOD
• Clean with a clean cloth wrung in water or in a solution
of water and a neutral detergent. Remove soap residue
immediately using a clean, dry cloth.
• If the surface is scratched or appears matt, use a care
product suited especially for lacquered or stained wood.
• Avoid using detergents containing silicone, as that
would seal the stain in and make subsequent repairs
more difficult.
• Avoid using scouring cream or scouring pads, as they
may scratch the surface.
UNTREATED WOOD
• Clean with a clean cloth wrung in water or in a solution
of water and a neutral detergent or soap flakes. Remove
soap residue immediately using a clean, dry cloth.
• To remove stains, clean and scrub using a thick
solution of soap flakes that is not allowed to stay on the
wood for more than 2 minutes. Then remove the
remaining soap residue using a damp cloth.
• If the grain of the wood rises after cleaning, gently
sand down the wood using fine-grit sandpaper (No. 220),
always going with the grain.
• If the surface is scratched or appears matt, use a care
product suited especially for untreated wood.
LAMINATE
• Clean with a clean cloth wrung in water or in a solution
of water and a neutral detergent. Remove soap residue
immediately using a clean, dry cloth.
• Stains may be carefully removed using household
ammonia or with a clean, damp cloth or a nanosponge
wrung in warm water. Never use the nanosponge dry.
Follow up immediately with a clean, dry cloth.
• Avoid using scouring cream or scouring pads, as they
may scratch the surface.
> CARE AND MAINTENANCE <
CAUTION
With a little care you can prolong the life of your
furniture and keep the materials in good condition.
Wood is a natural material, which may change in colour
and will patinate over time. Always remove stains quickly
before they can do any permanent damage to the
furniture.
• Avoid placing the table in direct sunlight or near a heat
source to reduce changes.
• When you move the furniture, make sure to lift it rather
than pulling or pushing it to avoid damaging the floor,
legs and mountings.
• Tighten up the screws after one to two months’ use.
• Avoid improper use such as putting your feet on the
table and standing on it.
• Use coasters under damp, hot or coloured objects to
avoid permanent stains.
• Avoid covering the surface partially, for example with
tablecloths or placemats, as colour variances may
appear.

A x 1 B x 4
Allen keyC x 20
> PARTS <
1.
While assembling, keep the table inside the cardboard box to protect the
tabletop from scratches etc. Make sure that all parts are included.

2.
Place the B parts and align them with the holes. Place part C in the holes. Gently tighten part C.
3.
Use the allen key to tighten the C parts completely.

4.
Flip the table.
5.

57 10441 209355
Havnen 1 8700 Horsens Denmark
[phone] / [e-mail]
H AY
ITEM NO. 706287