Hay FIFTY-FIFTY WALL User manual

– INSTRUCTION MANUAL –
DESIGN BY SAM WELLER
FIFTY-FIFTY WALL

 INTRODUCTION 
Named Fifty-Fifty after the lamp’s counterweight
system that creates equilibrium between the two
parts, it is clear to see how Sam Weller’s references to
physics and engineering influence the design. Based
on the idea of stripping a multi-purpose task light to
its fundamental elements, Fifty-Fifty balances refined,
pared-back aesthetics with optimal functionality.
This largest and latest addition to the Fifty-Fifty
family, the Wall mounted lamp, uses most of the same
components as the rest of the family, with configurable
aluminium components and robust steel wall brackets
and counter weight. The extruded cantilever arm
is easy to tilt and pivot, featuring a touch-sensitive
dimmer switch for precisely positioning and
controlling the integrated LED light source.
The Fifty-Fifty wall lamp is suitable for using in
offices, public spaces and private homes.

TECHNICAL DATA
This product is supplied with an integrated
LED module (3000k warm white, 600700
lumen). The expected lifespan of the LED
module is 25,000 hours.
/When the light source reaches its end
of life, the whole luminaire should be
replaced.
ATTENTION
In some countries, electrical installations
must be carried out by authorised
electricians/contractors; please check
with your local authority for guidance.
/HAY accepts no responsibility for any
products that have been modifed or
tampered with.
CARE AND MAINTENANCE
The product can be cleaned with a soft
damp cloth and mild detergent.
/Do not use alcohol or any other solvents
to clean the product.
/The external flexible cable or cord of this
luminaire cannot be replaced; if the cord
is damaged, the luminaire should be
destroyed.
 PARTS  CARE AND MAINTENANCE 

Wall plugs Screws Allen key
Lamp
Adapter Power supply
Handle
 PARTS 

1.
The arm has three different settings allowing for different degrees of freedom
in a vertical direction. Choose the setting most suitable for your needs.
Side views
Setting 2
Setting 1
Setting 3 (default)
30°
5°
30°
10°
17.5°
17.5°

2.
If you would like to change between the three different settings for the arm - simply
loosen the screw on the adjustment slider (step 1), change the slider’s position (step 2)
to the setting you require (step 3) and aligning the screw with the pre-defined hole
and tighten the screw. It is suggested that two people carry out this step.
Step 1
Step 2
Step 3
Setting 1
Setting 1
Setting 1
Setting 2
Setting 2
Setting 2
Setting 3
Setting 3
Setting 3

3.
The head of Fifty-Fifty /Wall is flexible and can be moved sideways and up and down.
The arm also allows for a 180 degree horizontal movement.
50°
50°
Side view Front view
90°
90°90°
90°
Top view

4.
Using the lamp’s wall bracket as a guide, mark the position of the holes to be drilled
(640 mm apart). Use a spirit level to ensure that the wall bracket is level.

5.
Drill the holes using the correct type of drill for the wall you are drilling into.

6.
Insert the wall plugs. Ensure you use the correct type of plugs for the type of wall.

7.
Fix the wall bracket onto the wall using the provided screws, starting from the top.

8.
Screw the handle into the head, ensuring it is tight before using it to adjust the lamp’s
position. The lamp can be freely moved and will hold in any position. A touch sensitive
step dimming switch is located on the backside of the lamp’s head.

9.
Plug the trailing cable into the power supply. Attach the correct adapter for your region.
The lamp is now ready for use.

Havnen 1 8700 Horsens Denmark
[phone] / [e-mail]
021720