Chroma Inspire 632-9110 User manual

InspireTM Spreader Lens Kit QSG V3.0 QSG P/N: 632-0715
Quick Start Guide
Chroma-Q®
Inspire™
Spreader Lens Accessory Kit
For a full product manual please visit www.chroma-q.com
Part Number: CQINSLK
Model: 632-9110
For use with
Part Number: CHINHL*
Model: 632-XXXX

InspireTM Spreader Lens Kit QSG V3.0 QSG P/N: 632-0715
1. Overview
The Chroma-Q®Inspire™ Spreader Lens Accessory Kit has two volumetric light
shaping diffusers (VLSD), which can be attached to the fixture to achieve wider beam
angles at a given distance. For a complete list of accessories please visit
www.chroma-q.com.
2. Kit Contents
Items
Model
Quantity
Instruction Spreader Lens Inspire
632-0715
1
Holographic Film 20 Deg.
900-9116
1
Holographic Film 40 Deg.
900-9118
1
3. Safety
Caution
1. This product is for professional use only. It is NOT intended for
domestic or outdoor use.
2. The bright flash of light during power-up and continuous strobe effect
may cause epileptic seizure.
3. This product must be used with safety cable.
4. Tools Required
Screwdriver with PH#1 for the 2 X M3 flat head screw (Minimum Torque: 0.61 Nm / 5.5
in-lb).
Note: Micro-lens side (dull side) should face on the inside and shiny side should face
towards the outside at all times to achieve the above beam spread

InspireTM Spreader Lens Kit QSG V3.0 QSG P/N: 632-0715
5. Procedure
i. Remove the Bezel by taking out 2 M3 flat head screws using PH#1 screwdriver,
save them for later.
ii. Keeping the permanent lens in place, the spreader lens has two clearance holes
diametrically opposite to match the position of the mounting holes for the Bezel
iii. Add the spreader lens –dull side facing inwards –on top of the permanent lens
making sure that the mounting underneath can be reached. Tighten the 2 X M3
flat head screws removed from the bezel.
iv. The two provided lenses in the kit are side specific and are marked
a. Medium Lens (900-9116) for approx. 42◦beam angle
b. Wide Lens (900-9118) for approx. 65◦beam angle
Note: During installation keep the shiny side of the lens to the outside. It has been
marked with the specified degree sticker on it.
6. Further Information
Please refer to the Chroma-Q®InspireTM manual for more detailed information. A copy
of the manual can be found at the Chroma-Q®website –www.chroma-
q.com/support/downloads

InspireTM Spreader Lens Kit QSG V3.0 QSG P/N: 632-0715
Approvals & Disclaimer
The information contained herein is offered in good faith andisbelieved to be accurate.
However, because conditions and methods of use of our products are beyond our
control,this informationshould notbe used in substitutionfor customer's teststoensure
that Chroma-Q®products are safe, effective, andfully satisfactory for the intended end
use. Suggestions of use shall not be taken as inducements to infringe any patent.
Chroma-Q®sole warranty is that the product will meet the Chroma-Q®sales
specifications in effect at the time of shipment. Your exclusive remedy for breach of
such warranty is limited to refund of purchase price or replacement of any product
shown to be other than as warranted.
Chroma-Q®reserves the right to change or make alteration to devices and their
functionality without notice due to on-going research and development.
The Chroma-Q®InspireTM has been designed specifically for the lighting industry.
Regular maintenance should be performed to ensure that the products perform well in
the entertainment environment.
If you experience any difficulties with any Chroma-Q®products please contact your
selling dealer. If your selling dealer is unable to help, please contact
[e-mail]. If the selling dealer is unable to satisfy your servicing needs,
please contact the following for full factory service:
Outside North America:
Tel: [phone]
Fax: [phone]
suppo[email protected]m
North America:
Tel: [phone]
Fax: [phone]
suppo[email protected]m
For further information please visit the Chroma-Q®website at www.chroma-q.com.
Chroma-Q®is a trademark, for more information on this visit
www.chroma-q.com/trademarks.
The rights and ownership of all trademarks are recognized