Heart of House Elford 3 Drawer Bedside Chest User manual

Elford - 3 Drawer Narrow Chest
Dimensions
Width - 50cm
Depth - 44.2cm
Height - 74.4cm
Assembly Instructions - Please keep for future reference 237/5465
259/7968
246/9182
Important – Please read these instructions fully before starting assembly
BK02740 - Issue 1 - 29/05/2014
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6403030

1
Safety and Care Advice
Important – Please read these instructions fully before starting assembly
Note: if required the next
page can be cut out and used
as reference throughout the
assembly. Keep this page with
these instructions for future
reference.
• Check you have all the
components and tools listed on
pages 2 and 3.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• Do not stand or put weight on
the product, this could cause
damage.
• Assemble the item as close
to its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Do not use extended drawers
to aid standing. Do not stand on
extended drawers.
• Do not over load drawers,
the maximum load per drawer
should not exceed 3kg.
• To prevent bowing of shelves
do not over load, and always
distribute weight evenly.
• If a residual aroma is
experienced with your new
furniture after the packaging
is removed simply ensure the
room is well ventilated and this
will assist a speedy removal
• We do not
recommend the
use of power
drill/drivers for
inserting screws,
as this could damage the unit.
Only use hand screwdrivers.
• Dispose of all packaging
carefully and responsibly.
• It is essential that this unit be
fixed to a wall with the fittings
provided.
• Parts of the assembly will be
easier with 2 people.
• Please retain the product label
on the back of the unit, as this
information will help support any
queries.
• Dust with a clean cloth or, if
required a slightly damp cool
cloth. Do not use household
cleaners, abrasives or polishes
as permanent damage may
occur.
• Do not drag the furniture or lift
it by its top.
• Avoid sharp objects, contact
with water and direct heat on all
surfaces
• Your furniture is finished to the
required colour. Avoid exposure
to strong sunlight as this can
change the colour. Change in
appearence may also occur if
items are permanently left on a
surface.
• Drawers should be secured or
removed before moving.
• You should get assistance
when moving or lifting your
furniture. Furniture consisting of
more than one unit should be
disassembled before attempting
to move it.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Care and maintenance - Non compliance with this information may affect your guarantee
Handy Hints
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the
bolts.
• Regularly check and ensure
that all boths and fittings are
tightened properly.

Components - Panels
Please check you have all the panels listed below
2
3 Drawer narrow chest (74.4 x 50 x 44.2cm)
1
If you have damaged or missing components, call the
Customer Helpline:
Argos = 0345 6403030

3
Please check you have all the fittings listed below
15mm Screw x 1
Tools required
A
15mm Washer x 2
B
Wall strap x 1
C
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
Components - Fittings
Phillips screwdriver
(medium)
The following components are pre-fitted and are illustrated for reference only.
Bar handle x 3 20mm Handle screw x 6
Ruler - Use this ruler to help correctly identify the screws
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 110 115 120 125 130 135 140 145 150 155 160 165 170
105
The screws length is measured from the head to the point (30mm screw shown) .

4
Assembly Instructions
Step 1
Remove and replace
handle
a: Position the unit in the
required position. The bar
handles are fitted to the
inside of the unit, using
a Philips screwdriver
unscrew the 20mm
handle screws in each
handle and remove both
the 20mm handle screw
and the bar handle.
b: Replace the bar
handle on the front of
the unit. Fix in position
by screwing the 20mm
handle screw into each
bar handle from inside
the unit using a Philips
screwdriver.
Note: Only use the
20mm handle screw that
the handles were pre-
fitted with.
20mm Handle screw
Bar handle
20mm Handle screw
a:
b:
1
1
Philips screwdriver
Philips screwdriver
1

5
Assembly Instructions
Step 2
Fixing to wall
It is recommended that
the chest is fixed to a
wall
Fix wall strap Cto the
back of the chest top
using 15mm screw A
and 15mm washer B.
Warning: The
15mm screw A
is for fixing the
wall strap Cto furniture
only. In addition to this
you will need to choose
a screw or fitting which is
suitable for securing the
wall strap Cto the type
of walls you have. If you
are unsure about what
type of screw to use seek
professional help.
Assembly is complete.
1
CUsing the correct type of
screw, screw through the
washer and wall strap
into a pre-drilled hole in
the wall
Back Panel
Unit Top
A
B
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6403030