Heat & Glo MEZZO-1000-AU User manual

AUSTRALIAN
RECOMMENDED MEZZO
INSTALLATION
INSTRUCTION
FOR MODELS:
MEZZO-1000-AU
MEZZO-1300-AU
MEZZO-1300ST-AU
MEZZO-1600-AU
23/03/2017 Ver.1

MEZZO FIBRE CEMENT SHEETING
INSTALLATION INSTRUCTION
ONE PIECE 9mm FIBRE
CEMENT SHEETING
CEMENT SHEETING JOINT TO BE
NEAR BOTTOM OF UNIT WHERE IT WILL
BE COOLER
MEZZO HEAT BOARD TO SIT
FLUSH WITH TIMBER FRAME
9mm FIBRE CEMENT SHEETING
IMPORTANT:
•Wall lining is to be fixed to timber frame only
•At no point is the wall lining to be screwed or
glued to the unit.
•The unit must be able to expand and contract
independently to the frame and wall lining,
otherwise cracking will occur.
•Unit and heat board is to finish flush with front
of timber frame so that 9mm wall lining can be
correctly finished
•If the fibre cement sheeting is to be fixed to the
heat board, Selleys 401 silicone must be used
to allow for expansion.
23/03/2017 Ver.1 2
TIMBER FRAME

MEZZO FRAMING DIMENSIONS
Variant Vent opening (A) Opening height (B) Opening depth (C) Opening width (D)
MEZZO-1000-AU 254 1085 477 1275
MEZZO-1300-AU 254 1085 477 1580
MEZZO-1600-AU 254 1237 478 1885
MEZZO AUSTRALIAN FRAMING
DIMENSIONS
23/03/2017 Ver.1 3

MEZZO SEE THROUGH AUSTRALIAN
FRAMING DIMENSIONS
MEZZO SEE THROUGH FRAMING DIMENSIONS
Variant Vent opening Opening height Opening depth Opening width
MEZZO-1300ST-AU 254 1085 464 1580
23/03/2017 Ver.1 4

MEZZO SEE-THROUGH AUSTRALIAN
SHEETING ATTACHMENT DETAIL
9mm fibre cement
sheeting under the unit
9mm fibre cement
sheeting
Opening Opening
23/03/2017 Ver.1 5
A
Timber frame installed flush
with the heat board material
on the unit typical both sides.
9mm fibre cement
sheeting
heat board material
DETAIL A

MEZZO AUSTRALIAN SHEETING
ATTACHMENT DETAIL
Timber frame installed flush
with the heat board material
on the unit this side only.
9mm fibre cement
sheeting
9mm fibre cement
sheeting under the unit
Opening
25mm air gap from
rear of unit to timber
framing with fibre
cement sheeting.
23/03/2017 Ver.1 6
heat board material
A
DETAIL A