Heat Outdoors Shadow Operation and maintenance manual

Shadow 3 Phase Industrial
Infared Heaters
Safety Instructions and Operation Manual
903671-15 Shadow 9kW Horizontal
903671 Shadow 12kW Horizontal
903672-15 Shadow 13.5kW Vertical
903672 Shadow 18kW Vertical
Heat Outdoors
Unit 9, Stort Valley Industrial Estate
Stansted Road, Bishop’s Stortford
Hertfordshire, United Kingdom
CM23 2TU
Available at
www.heat-outdoors.co.uk
01279 466500
[email protected]

2Contents
Contents
Important Information . . . . . . . . . . . . . . . 3
Safety Instructions . . . . . . . . . . . . . . . . . 4
Assembly Instructions . . . . . . . . . . . . . . . 6
Operation . . . . . . . . . . . . . . . . . . . . . 7
Product Diagrams . . . . . . . . . . . . . . . . . 8
Wiring Diagram . . . . . . . . . . . . . . . . . . 9
Cleaning & Maintenance . . . . . . . . . . . . . 10
Technical Specications Table . . . . . . . . . . . 11
Customer Service . . . . . . . . . . . . . . . . 12

3
Brief Introduction
Brief Introduction
Shadow industrial and warehouse infrared heaters combine the market-leading Ultra Low
Glare infrared lamp technology with advanced outer casing construction, allowing you to
achieve instant short-wave infrared heat in the desired area.
The Shadow 3-phase Industrial Heaters can be mounted wherever you like and are
designed for heating large-sized industial spaces.
Important Information
Please carefully read all instructions provided before using this appliance. This heater
must be installed and used as instructed.
This Operation Manual contains the important safety information, as well as some
recommendations on correct use, installation and maintenance of the appliance.
When operating this infrared heater observe necessary safety precautions, improper use
may result in injury or damage to property.
Ensure to keep this manual along with your sales receipt, and if possible, cardboard
package and packing material in case return of the unit is necessary.
• Unpack the infared heater making sure that all the items are
present, there are no components left in the box and the heater head
is free from any packing material.
• Using the detailed diagrams follow the steps to assemble your
infared heater.
• Do not connect the infrared heater to the electrical supply until the
assembly is complete.
• Do not connect the infared heater to the electrical supply if any of
the components or the power cord is damaged in any way.

Safety Instructions
4
Safety Instructions
Read these instructions before using.
WARNING
Potential re risk if the heater is covered by any material or positioned close to curtains
or other ammable materials.
• This appliance can be used by children aged 8 years+, and persons with reduced
physical, sensory or mental capabilities if they have been instructed to use the
appliance in a safe way.
• Children of less than 3 years should be kept away unless continuously supervised.
• Children aged between 3-8 years shall only switch on/off the appliance provided
that it has been placed in its intended operating position.
• Children aged between 3-8 years shall not plug in, regulate, clean or perform
maintenance on the appliance.
• CAUTION — Some parts of this product can become very hot and cause burns.
Particular attention has to be given where children and vulnerable people are
present. Do not touch the appliance during operation to avoid the risk of injury.
• Check that the voltage indicated on the nameplate of the appliance corresponds to
the local mains voltage before you connect the appliance.
• Both the power supply to the appliance and extension cords and multi-sockets
should correspond to the relevant regulations of the power supply companies and
the regional construction regulations. Extension cords and multi-sockets may be
used only if care is exercised in their use.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or a similarly qualied person to avoid a hazard.
• To avoid overheating, please do not cover the heater.
• The heater must not be located immediately below a socket outlet.
• The heater must be installed at least 1.8 m above the oor.
• After xing to a wall or ceiling, adjustments to the direction of radiation must only
be made with the appropriate tools.
• Do not use the heater with a programmer, separate remote control system or any
other device that switches the heater on/off automatically.
• It can become a re risk if the heater is covered or positioned incorrectly.
• It’s dangerous to install the heater close to curtains and other combustible
materials such as curtains, marquees, ags plastic foils etc.
• Do not use the heater in reach of a shower, bath or a swimming pool.

5
Safety Instructions
• Do not use in unventilated areas.
• Do not use where gas, petrol, paint or other ammable materials are stored.
• Do not push any items through, obstruct or cover the grills of the heater head.
• Do not let the cord hang over the edge of a table or counter, or touch hot surfaces.
• Do not move the heater when it is connected to electrical supply.
• Always wait till the heater has cooled down completely before putting into storage.
• Do not touch the heater head during in use.
• Do not leave the heater turned on and unattended especially when children and or
animals are in the vicinity.
• The heater must be placed with a clearance of 100cm to the wall and 50cm to
the ceiling.
• The heater gets extremely hot during operation and stays hot for a period after
shutdown. Potential danger will occur when touching it during this period.
• The heater must be handled with care, no violent vibration or hitting.
• Improper use of the appliance can result in electric shock or re hazard. The
appliance must be pulled from removed from the mains plug immediately.
• In case of damage, it must be repaired by a professional electrician.
• This heater is not equipped with a device to control room temperature. Do not use
this heater in small rooms where they are occupied by persons not capable of
leaving the room on their own.
• Remove the unit from the power outlet and wait until the appliance is sufciently
cooled off before cleaning.
• Do not use the heater as a cloth drier or tower drier.
• Do not use the heater as a sauna heater.
• Do not use the heater as a room heater.
• Do not use the heater in place of animal propagating and raising.
• Do not immerse the heater into water for cleaning.

Assembly Instructions
6
When unpacking the heater, please make sure that all the items are present, there are no
components left in the box and that all the parts are free from any
packing material and are not damaged. Ensure that the materials used for mounting
(dowels and screws) are stable and secure enough to mounting and holding the
appliance in place.
Do not connect the heater to the electrical supply until all the assembly is done.
Do not connect the heater to the electrical supply if any of the components or power
cord are damaged any way. If in doubt, please
contact your local supplier.
A: Wall Mounting
1. Mark and drill 4 holes 10mm in diameter
on the wall.
Assembly Instructions
2. Insert 4 expansion bolts into the holes,
align the heater onto the bolts and lock
with 4 nuts tightly.
The two diagrams below demonstrate the minimum safe mounting distance between the
appliance and the ceiling, wall, and oor. (The rst diagram shows the 12kW heater and
second shows the 18kW).

7
Assembly Instructions
B: Angle Adjustment
• Loosen the nuts on both sides, adjust
the heater to the desired angle.
Tighten the nuts to seal in place.
Ensure the screws are securely
connected. The screws could loosen
due to mechanical bearing pressure
and oscillation due to wind or rain.
Operation
• Insert the plug into the power socket.
• After plugging in appliance to the power source, wait
10-15 minutes to make sure that the appliance is
working normally.
• Press the ON/OFF button to turn on the heater.
• To switch off the heater, please press the ON/OFF
button again.
• During long periods of inactivity, please remove the
plug from the power socket.
• The power setting on the heater allows you to turn the
heater on/off or adjust the power manually.
OFF/ONMIN
MAX

Product diagams
8
Horizontal
Vertical
Product diagams
1292mm
390mm
184mm
857mm
525mm
184mm

9
Wiring Diagram
Wiring Diagram

10 Cleaning & Maintenance
Cleaning & Maintenance
• Disconnect the appliance from the power supply system.
• After the appliance has cooled down, the housing can be wiped clean with a
damp cloth.
• Wipe the appliance only with a clean and lint-free cloth or a soft brush.
• Do not touch the bulb element with your ngers. Stains can build up from touching
the bulb and may cause the bulb to malfunction.
• Do not use any abrasive or hard cleaning products on any part of this heater.
• Do not immerse the cord, plug or appliance in water as this can cause electric shock
and danger to life.
• Wait until the unit is completely dry before use.
• When cleaning the reector, contact a qualied electrician to see if the relector needs
to be removed.
https://www.heat-outdoors.co.uk/help-desk/useful-articles/heater-and-lamp-
maintenance.html
Any maintenance or repairs should only be carried out by a qualied electrician if you’re
unsure how to do so. For further information and guidance, visit our online help articles
and videos.

11
Technical Specications
Technical Specications
Cable length: 2.05m (1.5mm²) (2.5mm²)
Ingress Rating: IP65
Replacement lamp part no:
903670L15 903670L

12 Customer Service
Disposal
In accordance with European Directive 2001/96/EG concerning used
electrical and electronic appliances (waste electrical and electronic
equipment – WEEE), please return any electrical equipment that you will
no longer use to the collection points provided for their disposal.
This symbol indicates that the appliance cannot be treated as normal domestic waste,
but must be handed to a collection point for recycling electric and electronic appliances.
Information concerning where the equipment can be disposed of can be obtained from
your local authority.
Storage
If the heater won’t be used for a long period of time, store it in a cool, dry location. To
prevent dust and dirt build-up, use the original packaging to repack the heater.
Customer Service
• Repairs must be carried out by authorised specialists, thus ensuring electrical safety.
• Please contact us or a suitably qualied electrician.
• Improper repairs could lead to danger to the user.
Warranty does not cover damage or failure which results from alteration, accident,
misuse, abuse, neglect, commercial use or improper maintenance. In line with our policy
of continuous product development we reserve the right to change the product and
documentation specications without notice.

Unit 9, Stort Valley Industrial Estate
Stansted Road, Bishop’s Stortford
Hertfordshire, United Kingdom
CM23 2TU
Avaiable at
www.heat-outdoors.co.uk
01279 466500
[email protected]