Heat Outdoors 901199C Operation and maintenance manual

Shadow Parasol Heater
Safety Instructions and Operation Manual
901199C
Heat Outdoors
Unit 9, Stort Valley Industrial Estate
Stansted Road, Bishop’s Stortford
Hertfordshire, United Kingdom
CM23 2TU
www.heat-outdoors.co.uk
01279 466500
[email protected]

2Contents
Contents
Brief Introduction . . . . . . . . . . . . . . . . . 3
Technical Specications . . . . . . . . . . . . . . 3
Safety Instructions . . . . . . . . . . . . . . . . . 4
Installation Instructions . . . . . . . . . . . . . . . 6
Product Diagrams . . . . . . . . . . . . . . . . . 7
Operation Instructions . . . . . . . . . . . . . . . 8
Customer Service . . . . . . . . . . . . . . . . 10

3
Brief Introduction
Brief Introduction
This product is a short-wave infrared radiant heater with remote control and IP 65
approved. It is universally used in outdoor settings such as open bars, courtyards,
plazas, stations or home patio at any time of year. This patio heater is energy‐ecient,
convenient, environmentally friendly and ideal to improve the comfort and enjoyment of
being outdoors.
Technical Specications
Model No. 901199C
Voltage (V) 240V~
Power (W) 3000W
Installation Pole / Parasol
Product Dimensions (mm) 730*640*170
Weight (Kg) 2.8kg
Infrared receiving angle 60°±5°
Water Ingress Protection IP65

4Safety Instructions
Safety Instructions
Read these instructions before using this heater.
CAUTION!
Risk of scald injury!
When using electrical appliances, basic safety precautions should always be followed to
reduce the risk of re, electric shock, or injury to persons, including the following:
• This heater is hot when in use. To avoid burns, DO NOT let bare skin touch hot
surfaces. Keep combustible materials, such as furniture, fabrics, paper, clothes and
curtains at least 0.9m from the front of the heater.
• Extreme caution is necessary when any heater is used by or near children or
vulnerable people and whenever the heater is left operating and unattended.
• Always unplug the heater when not in use.
• DO NOT operate any heater with a damaged cord or plug or if the heater
malfunctions, has been dropped or damaged in any manner. Discard heater, or
return to an authorised service facility for examination and/or repair.
• DO NOT try to repair the appliance by yourself.
• This heater is NOT intended for use in bathrooms, laundry areas and similar
locations. Never locate heater where it may fall into a bathtub or other water
container.
• DO NOT run the power cable under carpeting, throw rugs, runners, or similar
coverings.
• DO NOT route cord under furniture or appliances.
• Arrange cord away from high trac areas or where it may become a trip hazard.
• Connect to properly grounded outlets only.
• To disconnect heater, turn controls off, then remove plug from outlet.
• DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening
as this may cause an electric shock or re, or damage the heater.
• To prevent a possible re, DO NOT block air intakes or exhaust in any manner.
• DO NOT use on soft surfaces, like a bed, where openings may become blocked.
• A heater has hot and arcing or sparking parts inside. DO NOT use it in areas where
gasoline, paint, or ammable liquids are used or stored.
• Use this heater only as described in this manual. Any other use not recommended
by the manufacturer may cause re, electric shock, or injury to persons.
• Always plug heaters directly into a wall outlet/receptacle. Never use with an
extension cord or relocatable power tap (outlet/power strip).
• Check if the voltage indicated on the nameplate of the appliance corresponds to the

5
Safety Instructions
local mains voltage before you connect the appliance.
• The appliance is NOT located immediately below a wall socket‐outlet.
• The casing and the front cover of the appliance become extremely hot during
operation. Pay attention that, no combustible material due to wind or other
environmental inuences covers or obstructs the appliance, such as curtains,
marquees, ags, plastic foil etc. DO NOT touch the appliance.
• Improper use can result in electrical shock and/or re hazard.
• Remove the plug from the power outlet and wait until the appliance is suciently
cooled off before cleaning.
• Keep out of reach of children. In order to keep children from the dangers of
electrical appliances, never leave them unsupervised with the machine.
• When selecting the location for your machine, do so in such a way that children do
not have access to the machine.
• The appliance must only be mounted by an authorized person who has read and
understood these safety instructions, paying attention to the relevant regulations of
the power supply and the regional construction regulations.

6Installation Instructions
Installation Instructions
• It is highly recommended to seek help from another person when installing
this heater.
• Remove all package material (including any anti‐vibration foam surrounding
the lamp)
• Check the appliance, supply cord and the plug for signs of damage.
1. Ensure the mounting pole and all mounting parts (mounting pole, mounting
clamp etc) are suitable and stable enough to provide lasting support to the
heater. The mounting pole should be 30-50mm in diameter (Fig 2.)
2. Before mounting, the minimum safe mounting distances and tilt angles
shown in the gures must be strictly followed:
• The distance between the bottom edge of the appliance and the oor
must be at least 1.8m.
• There must be a distance of at least 0.25m between the appliance and the
ceilings, roofs or other covers.
• There must be a distance of at least 0.5 M at each side between the
appliance and walls, fabric or the like.
• Ensure the parasol heater is not mounted in a position which is not
susceptible excessive wind load.
3. Remove the Clamp Section from the heater assembly by sliding it vertically
upwards out of the grooved sections.
4. Attach the heater by aligning the xing pole inside the cavity created by
removing the Clamp Section.
5. Ensure the ON/OFF switch controls are facing downwards.
6. Slide the Clamp Section vertically back into the grooves and tighten the
Fastening Clamp to secure the heater.
7. Adjust the desired angle of heaters. Regularly check the fastening clamp is
tight. Vibration from the wind or rain can lead to loosening of the attachment.
8. Disconnect from the power supply when the heater is not in use.

7
Product Diagrams
Product Diagrams
Fig 1.
Fig 2.
30.0-50.0mm
Heater No.3 Heater No.1
Heater No.2
Power LED and
IR Remote Receiver
Power switch
Fastening Clamp
Clamp Section

8Operation Instructions
Operation Instructions
Connect the power cable to a 220-240V, 13 amp supply.
Remote Control
Ensure the remote is pointed towards the IR Remote Receiver
on the underside of the clamp shown in Fig 2 (Page 7).
I Turn on heater No. 1
II Turn on heater No. 2
III Turn on heater No.3
ON Turn on all in turn
OFF Close all
Notes
• Use 2 x AAA size - 1.5V batteries in the
remote control.
• Remove the battery when not in use for long time, thus
extending the lifespan of the remote control.
• The remote control function may not work if there is a
barrier between the remote control and the heater, or
the IR remote is not pointing directly at the IR
Remote Receiver.

9
Operation Instructions
Cleaning & maintenance
Heater housing, grills and internal reectors
• Disconnect the appliance from the power supply.
• After the heater has cooled down, the housing can be wiped clean with a
damp cloth.
• Do not touch the glass bulb element with ngers, as small amounts of oil on the
bulb can cause it to malfunction.
• Do not use any abrasive or hard cleaning products on any part of this heater.
• Do not immerse the appliance in water.
• Wait until the unit is completely dry before use.
Cleaning of heater lamp
• Disconnect the appliance from the power supply system.
• Wipe the lamp over with a damp cloth ensure no detergents or cleaning uids are
used as they may cause damage to the lamp coating.
https://www.heat-outdoors.co.uk/help-desk/useful-articles/heater-and-lamp-
maintenance.html
Any maintenance or repairs should only be carried out by a qualied electrician.
For further information and guidance, visit our online help articles and videos.
Storage
If the heater will not be used for a long period of time, store it in a cool, dry location. To
prevent dust and dirt build-up, use the original packaging to repack the heater.

10 Customer Service
Disposal
In accordance with European Directive 2001/96/EG concerning used
electrical and electronic appliances (waste electrical and electronic
equipment – WEEE), please return any electrical equipment that you will no
longer use to the collection points provided for their disposal.
This symbol indicates that the appliance cannot be treated as normal
domestic trash, but must be handed to a collection point for recycling electric and
electronic appliances.
Information concerning where the equipment can be disposed of can be obtained from
your local authority.
Customer Service
• Repairs must be carried out by authorised specialists, thus ensuring electrical safety.
• Please contact us or a suitably qualied electrician.
• Improper repairs could lead to danger to the user.
Warranty does not cover damage or failure which results from alteration, accident,
misuse, abuse, neglect, commercial use or improper maintenance. In line with our policy
of continuous product development we reserve the right to change the product and
documentation specications without notice.

11
Customer Service

Heat Outdoors
Unit 9, Stort Valley Industrial Estate
Stansted Road, Bishop’s Stortford
Hertfordshire, United Kingdom
CM23 2TU
www.heat-outdoors.co.uk
01279 466500
[email protected]