Heat Outdoors SHADOW INFRARED PATIO HEATER Operation and maintenance manual

Heat Outdoors
SHADOW
INFRARED PATIO HEATER
Safety Instructions
and Operation Manual
Thank you for purchasing our products. Please read this instruction manual carefully before using
and operating. Please use in strict accordance with the instructions, and especially pay attention to
"Important Safety Instructions".
Brief Introduction
This product is infrared radiant heater. This product can be used in indoor and outdoor settings,
such as hotel lobby areas, open bars, restrooms, courtyards, shopping centers, travel station,
workshops, and construction sites in winter. This patio heater is energy efficient, convenient,
environmentally friendly and for better life
Important Safety Instructions
When using electrical appliances, basic safety precautions should always be followed to reduce the
risk of fire, electric shock, or injury to persons, etc.
Read through the operation and assembly instructions before operating the appliance.
• Extension cords and multi sockets may be used only if care is exercised in their use. The
marked electrical rating of the extension cord or multi socket should have adequate current
carrying capacity and correspond to the relevant regulations of the power supply companies
and the regional construction regulations.
• The appliance should not be located immediately below an electrical wall socket.
• Never install this appliance close to anything flammable, such as furniture, curtains, etc.
• In order to avoid overheating and fire hazard, do not cover or obstruct. Do not put any of the
following materials on the appliance, such as clothes, blanket, pillow, paper etc.
• Allow a minimum of 1M distance between the appliance and flammable materials must always
be maintained.
• Do not touch. Caution! Risk of injury!
• Do not let the cord hang over edge of table or counter, or touch hot surfaces.
• If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or
qualified electrician.
• As with any electrical appliance there is a risk of electrical shock and/or fire hazard if used
incorrectly. In case of damage , switch off the unit remove the mains plug from the socket
immediately.
• Remove the plug from the power outlet and wait until the appliance is sufficiently cooled
before cleaning.
• Keep out of reach of children. In order to keep children from the dangers of electrical
appliances, never leave them with a heater unsupervised, and ensure it is situated safely and
out of harms way.
Insta ation
For additional protection the installation of a residual current device (RCD) is advisable.
• Remove all package material (including anti vibration foam on the lamp) and check the
appliance, supply cord and the plug for signs of damage.
• Before mounting, the minimum safe mounting distances and tilt angles shown in the figures
must be strictly followed.
• The distance between the bottom edge of the appliance and the floor must be at least
1.8meter
• There must be a distance of at least 0.4 M between the appliance and the ceilings, roofs or
other covers

• Recommended degree to mounting surface is 45°. See figure 4.
• The infrared heater could also be adjusted slightly from left to right. The max. degree of
movement is 90°.
• Fix the mounting bracket on the wall securely. Alternatively this heater can be attached to
a heater stand.
• If mounted facing straight down, heaters need to be in a well ventilated area and must be at
least 0.5M away from any ceiling or obstructions to the airflow above them. See figure 3.
Figure 1: Mounting bracket (wall
bracket) and anchor raw plugs.
Figure 2: Connection from the stand to the
infrared heater. (Stands can be purchased
separately.)
Figure 3: Min. distance to floor, ceiling
and wall
Figure 4: Tilt angle
Hanging
Specifications
Voltage (V) □ 220 240V
Power (W) □ 1500W □ 2000W
□ 2×1500W □ 2×2000W
IP protection □ IP65
C eaning and Maintenance
• Before cleaning remove the plug from the power outlet and wait until the appliance is
sufficiently cooled.
• Wipe the appliance with clean lint free cloth or a soft brush.
• Never use abrasive cleaners, scrubbing brushes and chemical cleaners.
• To protect against electrical shock, do not immerse cord, plug, or any part of the heater in
water or other liquid.
• For heating element replacement ,please contact the manufacturer or its service agent or a
similarly qualified person.
Disposa
In accordance with European Directive 2002/96/EG concerning used electrical and
electronic appliances (waste electrical and electronic equipment – WEEE), please return
any electrical equipment that you will no longer use to the collection points provided for
their disposal.
This symbol indicates that the appliance cannot be treated as normal domestic trash, but
must be handed to a collection point for recycling electric and electronic appliances.
Information concerning where the equipment can be disposed of can be obtained from
your local authority.

Customer Service
• Repairs must be carried out by authorized specialists, thus ensuring electrical safety.
• Please contact the service agent or a suitably qualified electrician.
• Improper repairs could lead to danger to the user.
• This warranty does not cover damage of failure which results from alteration, accident,
misuse, abuse, neglect, commercial use or improper maintenance.
• In line with our policy of continuous product development we reserve the right to change the
product and documentation specifications without notice.
info@heat
-
outdoors.co.uk
[phone]
Unit 9, Stort Valley Industrial Estate
Bishops Stortford
Hertfordshire
CM23 2TU