6Setting of transmitterdata
1 2 3 4
Frequencies selection
3
PowerPower
OFF
ON
OFF
ON
TamperTamper
77
881122
33
44
55
66
NCNC
Frequency list
DIP 12345678
1
2
3
ON OFF ON OFF ON OFF ON OFF
OFF ON ON OFF OFF ON ON OFF
OFFOFF OFF OFF ONON ON ON
Empty
240240 5050
Response time adjustmentResponse time adjustment
TroubleTrouble PowerPower
AlarmAlarm
TamperTamper
77
8899
1010
1212 1111 1122
33
44
55
66
OFF
ON
OFF
ON DIP
15mm
Programming switch
7Setting of receiverdata
Receiver adopts electronicmemory chip tostore data,so itis not withDIP switch.Setting of receivingfrequency and NO/NC.
7.1 Status shift diagram
Keep pressing thetamper for
3 times within3 seconds, wh-
en there arebeep beep..
sound for towtimes, it enters
to parameter settingstatus.
Enter status of receiving frequency bands and NO/NC
Alarm light (siren):send out sound2 times
periodically, atthis time, LED4displays
NO/NC, LED3-LED1 displayreceiving bands.
Each receipt, thefunction switch LED4-LED1
add address 1and auto re-circle.
If function switchis not operated over 10 seconds
Working status
Non-alarm: alarm light
NC, siren nosound
Alarm: alarm lightNO,
siren keep sounding.
7.2 Setting diagram forreceiver
bands and alarmrelay NC/NO.
Press programming switch in 3 secretary
1
2
3
4
5
6
7
8
1
8
0 0 0
4 3 2 1
Signal LED
0 0 1
0 1 0
0 1 1
1 0 0
1 0 1
1 1 0
1 1 1
0 0 0
1 1 1
Note 1=NO 0=NC
1.Remove the cover 2.Attach the paper stencil onto the location
where the equipment is to be mounted, and
drill the holes in the positions on its mark.
3.Put the cable through the
hole for wiring.
4.Fix the main body onto the wall 5.Connect the cable to the wire terminal.
.Setting procedure
Wiring hole
TRANSMITTER
RECEIVER
TRANSMITTER
Frequencies
During operation status,press the tamperswitch by 3times within 3seconds, when thereare two longbeep sound, itent-
ers to parametersetting status, inthis status, sirenand alarm lightwill send out1 sounds periodical-lyin order tomention
that it isin the partof parameter setting.
ON/OFF Signal strengthindicator
One long beepsound means setting is ended and
automatic memory finished,returns to working status.
Bands
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
ON
Note: when poweris supplied, equipment address and frequency bands setting datafor 10
seconds automatically,and alarm light (siren) will offerrelevant indication.And then
it enters tooperation status.
