HELVAR LC-SRA User manual

Helvar | Data is subject to change without notice. I28 008 1 B 8.5.2019
LC-SRA
Strain Relief Installation Guide
1. Lock the bottom part to the driver so that it clicks into place.
2. Connect wires into correct terminals according to driver datasheet instructions.
NOTE for Active+ drivers
Ensure that the connector is properly inserted
and pushed firmly into place.
Avoid tension to the connector,
no pushing or pulling force.
Option 1.
Sensor / Control unit cable in the same slot with load cable Option 2.
Load cable separately in the center slot
(if load cable diameter > 4,8 mm)
Continues on the next page

3. Lock wires with the cable clamps.
Ensure that cables are tightly locked.
It’s recommended to use tool
to push the clamp
Check connections once more
after locking the clamps!
Helvar | Data is subject to change without notice. I28 008 1 B 8.5.2019
Ø 3 - 10 mm
Ø 4,8 - 12,5 mm
Ø 4,8 - 12,5 mm
4. Lock the cover on the bottom part.
Pay attention that
the cover clicks
into place properly!
LC-SRA
Strain Relief Installation Guide