NARGESA NOA60 Owner's manual

TECHNICAL FEATURES
PRADA NARGESA, S.L
Ctra. de Garrigàs a Sant Miquel s/n
17476 Palau de Santa Eulàlia (GIRONA) SPAIN
Tel. [phone] - [email protected]
www.nargesa.com
Inlet guide for edge
square bar
Ref. 140-11-01-00027
NOA60

GUIA DE ENTRADA PARA MACIZO CUADRADO AL CANTO 2
INDEX
1. Description of tooling ………………………………………………….………. 3
2. Identification of elements …….………………………………….…………….. 4
3. Setting up the tooling……….……..…………………………..………………. 4
4. Performance….…………………………………………………………...……. 5
5. Warnings…...…………………………………………………………………… 5
6. List of parts……………………………………………………………………….. 6

GUIA DE ENTRADA PARA MACIZO CUADRADO AL CANTO 3
1. Description of tooling
► Inlet guide for edge square bar
Inlet guide to emboss edge square bar up to 20mm or
3/4” inch
Ref: 140-11-01-00027
Weight: 18 Kg
► To emboss edge square bar, one set of embossing rollers 140-11-01-00026 is required
Rollers to emboss handrail up to 60 mm and
square bar up to 20 mm or 3/4” inch
Ref: 140-11-01-00026
Set per machine: 1
Weight : 11,4 Kg
Guide 140-11-01-00401, 140-11-01-00402,
140-11-01-00400or 140-11-01-00300 is
required
Ask the manufacturer about different
dimensions

GUIA DE ENTRADA PARA MACIZO CUADRADO AL CANTO 4
2. Identification of elements
The inlet guide to emboss solid square bar on the edge up to 20 mm or 3/4” inches is supplied completely
assembled with all necessary bolts to fix it to the machine..
3. Setting up the tooling
In order to fix the tooling to the embossing machine NOA60, it is required to adjust it by fastening the bolts
at the inlet guide of the machine as indicated in the pictures below:
1. Insert the tooling in the inlet guide of the
machine
2. fasten both fixing bolts to the tooling by
the lower part of the inlet guide of the ma-
chine.

GUIA DE ENTRADA PARA MACIZO CUADRADO AL CANTO 5
4. Performance
In order to start working with the inlet guide to emboss solid square bar on the edge, it is required to adjust
the upper rollers to the material. Turning clockwise around the upper Wheel of the tooling, these upper
rollers will move upwards. By turning the upper Wheel anti-clockwise, the upper rollers will go downwards.
We should make sure the material is properly fixwed and that it kees its position
5. Warnings
Keep the following instructions to safely use the Inlet guide for square bar on the edge.:
- Do not set or remove the tooling while the machine is running.
- Do not use the tooling for any other purpose but the ones described on this handling booklet.
- Use protection gloves to manipulate components and during the working process
- Use homologated protection googles and shoes.
- Hold the base material.

GUIA DE ENTRADA PARA MACIZO CUADRADO AL CANTO 6
6. List of parts