Henny Penny BM-110 User manual

FMOl-265

I, Turn On/Off switch to the ON position.
2. Place breading into drum. Drum will
hold up to 10 pounds of breading.
3. Feed raw moist product into hopper
assembly.
4. Product will emerge from the other end
of drum.
5. Place product into pan or wire grid for
frying process.
Do not place hands or objects into drum
while machine is operating.
1. Remove hopper (item 32) and hopper
stand (item 33) from unit.
2. Dissassemble end caps (item 36), blade
assembly (item 34), and cylinder
assembly (item 35) from drum (item 37).
All of these items can be taken to a sink
for easy cleaning.
3. Clean base of unit with a soft cloth and
soapy water.
Avoid getting water into motor and drive
compartment.

The following information will assist you when replacing components within the unit becomes necessary.
(Refer to exploded drawing.)
Place On/Off switch in the Off position and unplug the power cord from
the wall receptacle before attempting any replacement of components
2. Remove the switch mounting nut, locknut, the On/Off plate, and
remove the switch.
3. Place wires on new switch exactly as they were on the old switch.
4. Replace mounting nut, On/Off plate, and locknut, then tighten.
emove screws
2. Using a l/8” allen wrench, remove outer aluminum wheel and spacer
from drive shaft.
3.. Remove master link from chain and remove chain.
4. Slide drive shaft out and using a 3/32” allen wrench, loosen set screws
and remove large sprocket from drive shaft.
5. Replace large sprocket and assemble by reversing the above order.
Install new sprocket on drive shaft at the same location as old sprocket.
2. Remove master link from chain and remove chain.
3. Using a 3/32” allen wrench, loosen set screw and remove small
sprocket from motor.
4. Install new sprocket to motor.
emove screws
2. Loosen wire nut from motor wires and remove motor wires.
3. Using a 3/8” wrench and a phillips head screwdriver, remove four
screws and nuts holding motor to base.
4. Install new motor.
5. Place old fan blade on new motor.
Be sure motor wires are secure in wire nut. Use.electrical tape to hold nut.

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
Part No.
15859
x03-005
15020
sco5-001
15013
15014
NS02-002
15011
LWOI-002
15019
15018
sco5-001
15016
15017
sco5-003
15012
NS02-001
NS03-013
15023
Description
Base Cover
8 x l/2 PH
Chain
114 -20 x 318
Large Sprocket
Drive Shaft
l/4 x 20 Nut
Bearing Retainer
Split Ring Washer
Bearing - White Nyliner
Wheel Spacer
l/4 -20 x 3/B
Aluminum Wheel
Rubber Tire
IO-32 x l/8
Small Sprocket
lo-32 Hex Nut
Cage Nut 318
Fan Blade
1
14
1
4
1
2
8
4
8
4
4
4
4
4
4
1
5
4
1
and mounting nut)