Henny Penny BM-110 User manual

Model BM-110
OPERATING INSTRUCTIONS
1. TurnpowerswitchtotheONposition.
2. Placebreadingintodrum. Drumwillholdup
to10 pounds of breading.
3. Feedraw moist product into hopperassembly.
4. Productwill emerge fromtheotherendof drum.
5. Placeproductintopanorwiregridfor frying process.
Donotplace hands orobjectsinto drum whilemachineis
operating,orpersonalinjuryor damage tounitcould
result.
CLEANING (Refer to Exploded View)
1. Removehopper(32) and hopper stand (33)fromunit.
2. Dissassembleendcaps(36), blade assembly (34), and cylinder
assembly(34),andcylinderassembly(35)fromdrum (37). All
oftheseitems can be taken to asink foreasy cleaning.
3. Cleanbase of unit with asoftcloth and soapy water.
Do not use steel wool, other abrasive cleaners or
cleaners/sanitizers containing chlorine, bromine,iodine
or ammonia chemicals, as these will deteriorate the
stainless steel material and shorten the life of the unit.
Avoid getting water into motor and drive compartment, or
damage to electrical components could result.
MAINTENANCE INSTRUCTIONS
Thefollowinginformationwillassistyouwhenreplacing
componentswithin the unitbecomesnecessary. (Referto
explodeddrawing.)
1

Model BM-110
Toavoid electricalshock orproperty damage, move the
powerswitchtoOFFanddisconnectmaincircuit
breaker,or unplugcord at wallreceptacle.
POWERSWITCH 1. Removescrewsholdingbasecovertounitandremove.
2. Removethe switch mountingnut,locknut,andthe ON/OFF
plate,and remove the switch.
3. Placewireson new switch exactly as theywere onthe old
switch.
4. Replacemountingnut,ON/OFFplate,andlocknut,then
tighten.
LARGESPROCKET 1. Remove screws holding base cover to unit and remove.
2. Usinga 1/8”Allenwrench, removeouteraluminumwheel and
spacerfrom drive shaft.
3. Removemasterlinkfromchainand removechain.
4. Slidedrive shaft outandusinga3/32”Allenwrench,loosen
setscrewsandremovelargesprocket from drive shaft.
5. Replacelarge sprocket and assemble by reversing the
aboveorder.
Installnewsprocketon drive shaft at the same location
as old sprocket.
SMALLSPROCKET 1. Remove screws holding base cover to unit and remove.
2. Removemasterlinkfromchainand removechain.
3. Usinga 3/32”Allen wrench, loosen set screw and remove
smallsprocketfrommotor.
4. Installnew sprocket to motor.
MOTOR 1. Removescrews holding base cover to unit and remove.
2. Loosenwirenutfrommotorwiresandremovemotorwires.
3. Usinga 3/8” wrenchandaPhillipshead screwdriver, remove
fourscrews and nuts holding motor to base.
4. Installnew motor.
5. Placeoldfan blade on new motor.
Besure motor wires aresecure in wire nut. Use
electricaltape to hold nut.
2