When S3-1 is switched to ON, the lock becomes always opened.
2. Instruction：
2.1 Power connection
Connect positive pole of the power supply to +12V and negative pole to GND. After
turning on the power, the device beeps three ¡di¡.
2.2 Initialize the device
A. Press and hold S2 for 1 second. It will emit a short sound ¡di-¡.
B. Keep holding the S2 button for 5 seconds, then it will emit a long sound ¡di-----¡.
C. Release the S2 button, after 2 seconds it will emit 2 sounds ¡di---di---¡, it
indicates that all cards including Management Card, Setup Card and User Cards are
deleted.
2.3 Make a Management Card
A management card has the authorization to add setup cards.
A. Press and hold S2 button for 1 second.
B. After you hear a sound ¡di---¡, release the S2 button then you will hear a long
sound ¡di-------¡.
C. Then pass a new card (only one card), and you will hear a long sound ¡di------¡
and a short sound ¡di----¡. It indicates the success of making the Management
Card.
D. Two seconds later, you will hear three short sound ¡di----¡ which means the
operation is finished.
2.4 Add a Setup Card
A. Read the Management Card once.
B. After a long sound ¡di------¡, read a new card to be Setup Card (this operation
should be in 6 seconds).
C. After that, wait 6 seconds for the device to finish the operation.
D. If want to add more setup cards, please repeat step B.
Notice: It can make 126 pieces of Setup Cards.
2.5 Add a Mess-User Setup Card
Notice: It can only add two Mess-User Setup Card
A. Read the Management Card twice.
B. After a long sound ¡di------¡, read a new card to be Setup Card (this operation
should be in 6 seconds).
C. After that, wait 6 seconds for the device to finish the operation.
D. If want to add the other setup cards, please repeat step B.
2.6 Add a User Card
A. Read a Setup Card or once a Mess-User Setup Card.
B. After a long sound ¡di------¡, read a new card to be User Card (this operation
should be in 6 seconds).
C. After that, wait 6 seconds for the device to finish the operation.（Each Setup
Card can only add 8 User Cards and each Mess-User Setup Card can make
up to 200 User Cards.）
D. If want to add more setup cards, please repeat step B.
2.7 Add a User Card
A. Read a Setup Card once.
B. After a long sound ¡di------¡, read a new card to be User Card (this operation
Should be in 6 seconds).
C. After that, wait 6 seconds for the device to finish the operation.（Each Setup
Card can only add 8 User Cards）, and each Unit Setup Card can make up to
200 User Cards.）
D. If want to add more setup cards, please repeat step B
The relationship about Management Card, Setup Card, Mess-User Setup Card and User
Card
1
2
ON
S3
