Herowear Apex 2 EXO User manual

HANG ME WITH
YOUR APEX.
HeroWearExo.com
WEARING THE
Assemble the Apex 2 by sliding the top loop of the bands
through the metal carabiner on the clutch with the writing
on the bands facing outward. Lay the thigh sleeves with the
rubberized material and lettering facing down. Slide the
right band’s carabiner through the top of the right thigh
sleeve loop. Then slide the left band’s carabiner through
the top of the left thigh sleeve loop.
1
2
3
4Before putting on the thigh sleeves, ensure your right thigh
sleeve is on the right and the left thigh sleeve is on the left. Put
on the right thigh sleeve by grabbing the carabiner and pulling
down, ensuring the band is centered on the back of your leg
(below your buttock). Then buckle the thigh sleeve and adjust it
to your comfort level.
5Tighten the anchor strap by pulling
out and down on the loose end of the
webbing until at against the thigh. Do
not over tighten.
Fold loose webbing and secure in
webbing keeper.
v3.0EN
Tighten the shoulder straps
until the switch is on the
front of your shoulder.
Put the shouldes straps on like a backpack. Then
hook the G-hook through the corresponding
loop on the left shoulder strap and tighen until
comfortable.
1a
1b
Ensure that the anchor is aligned with
the outside seam on your pants, then
attach the hook to your belt.
6 7

HANG ME WITH
YOUR APEX.
USING THE
FIT CHECK
v3.0EN
Thigh sleeves should be in the middle of the thigh, not too low,
with the buckle on the side of each leg.
When standing upright with the suit disengaged, the bands should not be loose, and there
should not be more than 3 inches of rope extending from the clutch.
Adjust thigh sleeves so the bands pass over the middle
of each buttock. Bands should not be rotated too far
to the outside of the hips.
Ensure you have the perfect t. Scan the QR
code for more infomation.
https://support.HeroWearExo.com
You should be able to comfortably take a deep breath while
the suit is engaged, and you are in a fully bent position.
If you feel too restricted while fully bent or experience
soreness in your shoulders, adjust the shoulder straps and/
or chest strap until they are comfortable.
If the suit does not feel disengaged, return
to a fully upright standing position. (This is a
safety mechanism to ensure the clutch does
not disengage while under load)
ON
OFF
The Apex 2 exosuit does not increase strength or allow users to lift loads that are
heavier than they can typically lift. Always use good body mechanics and safe lifting
techniques when using the Apex 2
SAFETY CHECK
Engage the system by pulling down
on the yellow switch until it clicks.
Disengage the suit by pinching the
side of the yellow switch.