HIK VISION DS-TCG406-E User manual

Intelligent Entrance ANPR Camera
Quick Start Guide

Intelligent Entrance ANPR Camera •Quick Start Guide
I
Symbol Conventions
The symbols that may be found in this document are defined as follows.
Symbol
Description
Provides additional information to emphasize or supplement
important points of the main text.
Indicates a potentially hazardous situation, which if not avoided,
could result in equipment damage, data loss, performance
degradation, or unexpected results.
Indicates a hazard with a high level of risk, which if not avoided, will
result in death or serious injury.

Intelligent Entrance ANPR Camera •Quick Start Guide
II
TABLE OF CONTENTS
Chapter 1 Panel Interface ................................................................................................................ I
Chapter 2 Device Installation.......................................................................................................... 2
Install TF Card .................................................................................................................................................2
Install Device ..................................................................................................................................................2
Power on ........................................................................................................................................................4
Chapter 3 Device Configuration...................................................................................................... 5

Intelligent Entrance ANPR Camera •Quick Start Guide
I
Chapter 1 Panel Interface
The panel interfaces of Intelligent Entrance ANPR Camera are shown as below.
Panel Interface
Interface Description
Name
Description
Wiegand
Wiegand interface
RS-485
RS-485 communication interface
ALM-IN
Alarm input
ALM OUT
Alarm output
AUDIO IN
Audio input
AUDIO OUT
Audio output
RELAY OUT
Relay output

Intelligent Entrance ANPR Camera •Quick Start Guide
2
Chapter 2 Device Installation
Please check if there is any damage of the package first. According to the packing list, make sure no
item is lost. After checking all the items included, you can continue to install the device.
Install TF Card
The installation method of TF card is shown below.
Loosen the screws at the bottom of the camera, and remove the TF card cover.
Remove TF Card Cover
Insert the TF card, install the cover, and tighten the screws.
Install TF Card
Install Device
Before you start:

Intelligent Entrance ANPR Camera •Quick Start Guide
3
Cut off the power supply of the device.
Drill holes on the wall according to the installation template, and fix it on the wall with
expansion screws.
Install Rear Cover
Make sure the template is installed as the silk-screen UP indicates.
Thread internal cables through the wire holes, and tighten the screws to fix the junction box.
Install Junction Box
Fix the camera to the junction box with four screws.
Install Camera
Loosen the screw to adjust the angle of the camera, and tighten the screw after adjustment.

Intelligent Entrance ANPR Camera •Quick Start Guide
4
Power on
The cables should be well laid out and connected for normal device usage. Power on the device after
the device is installed correctly.
If the device fails to be powered on normally, please check whether the cables are connected correctly.
If the cables are connected correctly, go further to check the cable arrangement.
Adjust Angle

Intelligent Entrance ANPR Camera •Quick Start Guide
5
Chapter 3 Device Configuration
Scan the QR code below to get the user manual for detailed configuration.
User Manual QR Code

UD35550B