Hobby King Mariposa Trainer User manual

：
AIRCRAFT SPECIFICATIONS
Wing Span: 1121.5mm/44.15"
Wing Area: 30.12 Sq dm/ 466.9 Sq in
Length: 900mm/35.43in
Weight: 850g RTF less battery
：
RECOMMENDED EQUIPMENT
Motor: 2220/10
Radio: 3channels, 2 servos
Battery: 3S 2200mAh
ESC: 40A
Warning! This model is not a toy.
It is designed for maximum performance. Please seek advice if one is
not familiar with this kind of electric powered precision model.
Operating this model without prior preparation may cause in juries.
Remember, safety is the most important thing. Always keep this
instruction manual at hand for quick reference.

1.Stabilizer/Vertical/Tail Wheel
Stabilizer/Vertical/Tail Wheel Cut covering for control horn slot
Remove covering for vertical fin Cut covering at servo mount
Glue the vertical fin with CA glue Glue control horn to rudder with CA glue

Install rudder servo, secure with
screws
Attach rudder control rod with supplied
hardware
Assemble tail skid parts with CAglue Attach to stabilizer with supplied hardware
Glue control horn to elevator with CAglue Install elevator servo, secure with
screws

Attach elevator control rod with supplied
hardware
2.Wing assembly
Wing Parts Glue short fiberglass wing pins into center
wing panel with CA glue
Install plywood wing joiner with CA or
Epoxy. Dry fit first to make sure spar fits
correctly
Attach outer wing panels to center section
using epoxy glue

Insert wing dowels to fuselage, secure
with CA glue Attach wing to fuselage with rubber bands
3.Main Landing Wheel
Main Landing Gear Secure tires to landing gear with wheel
collars. One inside, one outside
Insert wire gear into fuselage. Hold in
place with plywood spacer.

Check wing, and tail distances to make sure all parts are installed straight and even