Hobby King Fly Baby-EP User manual

AIRCRAFT SPECIFICATIONS：
Wing Span: 1350mm/53.15"
WingArea: 30.29 Sq dm/ 469.4 Sq in Lenght:955mm/37.6in
Weight: 1200g RTF less battery
RECOMMENDED EQUIPMENT：
Motor: 2826
Radio: 4 channels, 4 servos
Battery: 3S/4S 2200mAh-3300mAh
ESC: 40-60A
Warning! This model is not a toy.
It is designed for maximum performance. Please seek advice if
one is not familiar with this kind of electric powered precision
model.
Operating this model without prior preparation may cause in
juries.
Remember, safety is the most important thing. Always keep this
instruction manual at hand for quick reference.

1.Wing / Main Landing Wheel
Wings Part List
Fix the hinge with instant glue
Cut the covering away for installing
the aileron servo
Cut the covering away for installing
the connection terminal
Fix the wing bolt with epoxy glue
Fix the aileron servo

Fix the aileron horn Completed the wing servo’s installing
Main Landing Wheel Part List Cut the covering away for fixing the
main landing gear
fix the main landing gear according the picture to passing the
shaft and 2pcs M3 nut through the
main landing gear

Fix the main wheel with 4pcs
self-locking nut
Fix the wings
Judging by the picture passes through
the steel wire and clamp the aluminium
connection terminal for fixing the steel
wire
Fix the connection terminal with
2pcs M3*40 cross head screw
,2pcs
M3*15 cross head screw
and
2pcs
M3*30 cross head screw;Then a
djust
the steel wire’s length and last
clamp the connection terminal
Fix the connection terminal t
hen
adjust the steel wire’
s
length
and
last clamp the connection terminal

2.Stabilizer/Vertical/Tail Wheel
Stabilizer / Vertical / Tail Wheel
Part List
Draw a line for cutting the covering
away
Judging by the line to cutting the
covering away
Fix the horizontal tail and the vertical
tail with instant glue
Cut the wood away for fixing the
elevator linkage rod
Drill a diameter 2mm hole for fixing
the elevator linkage rod

Fixing the elevator linkage rod with
epoxy glue
Fix the hinge with instant glue
Install the tail wheel and bend the steel
wire
Fix the tail wheel with 4pcs tapping
screws
Cut away the wood for fixing the tail wheel
steel wire
Drill a diameter 2mm hole for fixing the tail
wheel steel wire

Fix the rudder hinge with instant glue Fix the tail wheel steel wire with epoxy
glue
Fix the elevator and rudder’s horn
Install
the
elevator
and
rudder
push-and-pull rod
Completed
the
elevator
and
rudder
servo’s system installing

3.Canopy/Cowling/Motor Mounting
Cowl/Motor mounting Part List Fix the PVC ornament with epoxy glue
Fix the motor with 4pcs M3*15 socket
head screw
Draw a mark for drilling the cowling’s
hole
Judging by the mark to drilling the
hole
Fix the cowling

Install the canopy