Holman CLW60 User manual

Garden Light Controllers
CLW60, CLBW60 and CLBRGB60
2 Year Replacement Guarantee
Holman offers a 2 year replacement
guarantee with this product.
In Australia our goods come with guarantees that cannot
be excluded under the Australian Consumer Law. You
are entitled to a replacement or refund for a major failure
and compensation for any other reasonably foreseeable
loss or damage. You are also entitled to have the goods
repaired or replaced if the goods fail to be of acceptable
quality and the failure does not amount to a major failure.
As well as your statutory rights referred to above
and any other rights and remedies you have under
any other laws relating to your Holman product, we
also provide you with a Holman guarantee.
Holman guarantees this product against defects caused
by faulty workmanship and materials for 2 years domestic
use from the date of purchase. During this guarantee period
Holman will replace any defective product. Packaging
and instructions may not be replaced unless faulty.
In the event of a product being replaced during the guarantee
period, the guarantee on the replacement product will
expire 2 years from the purchase date of the original
product, not 2 years from the date of replacement.
To the extent permitted by law, this Holman Replacement
Guarantee excludes liability for consequential loss or any other
loss or damage caused to property of persons arising from
any cause whatsoever. It also excludes defects caused by
the product not being used in accordance with instructions,
accidental damage, misuse, or being tampered with by
unauthorised persons, excludes normal wear and tear and
does not cover the cost of claiming under the warranty or
transporting the goods to and from the place of purchase.
Should you suspect your product may be defective and need
some clarification or advice please contact us directly:
1300 716 188
[email protected].au
11 Walters Drive, Osborne Park 6017 WA
If you are certain your product is defective and is covered
by the terms of this warranty, you will need to present your
defective product and your purchase receipt as proof of
purchase to the place you purchased it from, where the
retailer will replace the product for you on our behalf.
Should you have any questions about this product or its operation
please telephone our customer service helpline on 1300 716 188
Head Office/Service
11 Walters Drive, Osborne Park WA 6017
Ph: [phone] Fax: [phone]
[email protected]
www.holmanindustries.com.au
Copyright © 2019 Holman Industries
Warranty Information
CLBRGB60 CLBW60 CLW60 Manual 2020 v2.indd 1CLBRGB60 CLBW60 CLW60 Manual 2020 v2.indd 1 23/7/20 12:36 pm23/7/20 12:36 pm

Garden Light Controllers
CLW60, CLBW60 and CLBRGB60
User Guide
2020CLW60 CLBW60 CLBRGB60
CLBRGB60 CLBW60 CLW60 Manual 2020 v2.indd 2CLBRGB60 CLBW60 CLW60 Manual 2020 v2.indd 2 23/7/20 12:36 pm23/7/20 12:36 pm

Mounting the Controller
Our Plug + Socket system means expansion is easy with no electrician required. Install the controller near
a 240V AC power point ideally located in a house, garage, or exterior electrical cubicle.
For ease of use, eye level placement is recommended. Ideally, your controller location should not be
exposed to rain or areas prone to flooding or heavy water. This controller comes with an internal transformer
installed in a weatherproof enclosure. The housing is designed for indoor or outdoor installation but the
power cable needs to be plugged into an outdoor power point under cover.
Drill a hole suitable for a wall plug and a insert a screw with a minimum 7mm wide screw-head. Hang
the controller over the screw head using the key hole slot positioned externally on the top centre of the
back of the controller. If your controller requires extra support you can drill an additional hole and fasten it
through the spare holes positioned internally under the terminal cover.
Connecting the Cables
Ensure you have the compatible cables for your controller.
CLBRGB60 4-Pin Plug + Socket
CLBW60, CLW60 2-Pin Plug + Socket
Connect the power cable to an outdoor power point. Ensure the socket is weatherproof if you have mounted
your controller outdoors. Ensure the Plug + Socket cable ends are touching and the caps are hand
tightened only. An end cap is provided on each cable to weatherproof the last connector.
Setup Example (Connect up to 60W of Lights)*
Only use lights within one colour system,
either RGB Colour 4-Pin Plug + Socket or Warm White 2-Pin Plug + Socket
These controllers have a capacity of 60W. Power is consumed by both the lights and the cable.
It is best to connect no more than 55W of lights, and no more than 75m of cable to a controller.
These controllers have an automatic power overload switch that will
turn the lights off if too much power is being consumed.
 Controller or Transformer
 Power Cable
 Extension Cable

Deck Lights
Spotlight

Path Light

Connection
Tees

Weatherproof
End Cap

CLBRGB60 CLBW60 CLW60 Manual 2020 v2.indd 3CLBRGB60 CLBW60 CLW60 Manual 2020 v2.indd 3 23/7/20 12:36 pm23/7/20 12:36 pm

Downloading iGardener™ (CLBW60 and CLBRGB60 only)
Step 1:
Download the iGardener
app from the App Store or
Google Play.
Step 2:
Enable Bluetooth®on your
device.
Step 3:
Ensure your controller is
connected to power. Open the
iGardener app and navigate
to Lighting 2018 Controller.
Visit www.holmanindustries.com.au/instruction-manuals for a comprehensive guide on using the iGardener™ app.
Bluetooth®compatible controllers are designed to be operated via the iGardener app. Our
Garden Light Transformer Hub (CLW60) is manually operated and does not require the app.
Lighting Scenes
SPOT LIGHTS
Contol your Spot Lights
at your Fingertips
Controlled by an innovative Bluetooth interface
Holman garden lights are fully operated at your
fingertips via the Holman lighting app. Holman
smart garden lights are connected on a 12V Safe
DIY Plug & Socket system so you can create a
commercial landscape design in your garden.
C
M
Y
CM
MY
CY
CMY
K
Spot Light Flyer.pdf 1 26/06/2017 1:52 PM
Contol your Deck Lights
at your Fingertips
Controlled by an innovative Bluetooth interface
Holman garden lights are fully operated at your
fingertips via the Holman lighting app. Holman
smart garden lights are connected on a 12V Safe
DIY Plug & Socket system so you can create a
commercial landscape design in your garden.
DECK LIGHTS
C
M
Y
CM
MY
CY
CMY
K
Deck Light flyer.pdf 1 26/06/2017 1:40 PM
Spotlights:
Great for illuminating individual
plants or trees and turning
them into a garden feature.
Path Lights:
Create a statement entrance
to your home by lighting
pathways around your
front door.
Deck Lights:
Light up the perimeter of your
deck to enhance your outdoor
entertaining area.
Troubleshooting
Lights are not turning on: Ensure the controller is connected to a power point and turned on. Check all
Plug & Socket cables are properly connected. Check that you have not connected too many lights to one
controller—do not exceed 60W. If you are using a Bluetooth controller check the lights are switched on via
the iGardener app.
Lights are too dim or not turning on: Connecting excessive lengths of cable will result in wattage loss.
Try to use the least amount of cable length as possible.
For more help, visit www.holmanindustries.com.au/garden-lighting-faqs
CLBRGB60 CLBW60 CLW60 Manual 2020 v2.indd 4CLBRGB60 CLBW60 CLW60 Manual 2020 v2.indd 4 23/7/20 12:36 pm23/7/20 12:36 pm