HOLOVISION 420-VIO2 User manual

From PoE Plus Switch or Injector
Manual Type 1.0.0.10 RF
Holovision VI 2 Intercom
For Models
420-VIO2
421-VIO2
Specifications
Communication
Holovision VoIP Intercom for use with Crestron,
SIP or Savant IPBx.
Access Control
Dry-contact relay availa le over the network
Link
Status
Power
Reset
Mic +
Mic -
Spk -
Spk +
Button
Button
Gnd
NC
NO
COM
12 VDC from Relay
OFF
PoE
On
VIO2
Everyday VoIP from Holovision
Out to Gate,Strike or Lock
INSTALLATI N
INSTRUCTI NS
501 E. Goetz Ave.
Santa Ana, Ca 92707
www.eholovision.com
Ph. 714-434-6904
Fax [phone]
H L VISI N



     

 

 
















      
#          

     















   

  


%&
  !"
"
   
  !##$"# 


'
      
VI (sip) QUICK START

 



 
22

VI RAVA Quick Start
1. Plug the device into the network. Device will speak it’s IP address.
2. Navigate to device IP on a we rowser.
3. Under “Configuration” please enter SIP ID for the name to e displayed, and enter the extension
of the Main RAVA Touchscreenunder “Input Call ID 0 Default is CALL:CRESTR N”
*Note out of the box the “CALL:CRESTR N” default will ring all touchpanels in the CRESTR N
call group.
4. Configure the Audio setiings. Note:RAVA peration has been designated to “Push to Talk” (PTT)
from Crestron and only this operation will be supported. Although full duplex and half duplex
are an option, these settingdo not perform est in all senarios. As a recommendation you can
experiment for the est audio settings.
AUDI SETTING BEL W ARE NLY A REC MMENDATI N

5. Configure the relay setting under “In ound Calls”. Configure the powered relay and the dry
contact closure. Choose any 2 to 4 digit com ination
Note; By configuring the request to exit feature you can configure for either relay.
6. Once the device has een configured you can initiate the call y pressing the utton

501 E. Goetz Ave.
Santa Ana, Ca 92707
Ph. 714-434-6904
Fax [phone]
www.eholovision.com