HOM Maxi Xilo User manual

Maxi Xilo |
COLLEZIONE HOM
INSTALLATION INSTRUCTION Pag. 2
ELECTRICAL RADIATOR

2
TECHNICAL DRAWING
VOLTAGE: 230 VOLT 50 Hz
NOMINAL POWER: 750 Watt / 1050 Watt /
1500 Watt
CLASS 1 ELECTRICAL APPLIANCE
PROTECTION CLASS: IP24
STANDARD REFERENCE: EN60335-1;
EN60335-2-30
TECH NICA L
DATA
140

ISTALL ONLY IN ZONE 3
Fig. A
3
HARDWARE TOOL
SAFE POSITIONING
VOLTAGE: 230 VOLT 50 Hz
NOMINAL POWER: 750 Watt / 1050 Watt /
1500 Watt
CLASS 1 ELECTRICAL APPLIANCE
PROTECTION CLASS: IP24
STANDARD REFERENCE: EN60335-1;
EN60335-2-30

4
/1
INSTALLING
SCHUKO VERSION
/2a

5
INSTALLING
/2b
APEL000021
(WALL VERSION)

6
/2c
INSTALLING

7
INSTALLING
/2b

Please read these instructions carefully
before beginning installation to ensure
the appliance is installed safety and
correctly.
Installation should be performed
by qualied professional only. Local
installation standards should be applied.
Before any operation remove the
packaging and check appliance
integrity. If any defect or damage are
noticed do not install or try to repair the
appliance but inform the retailer.
The packaging should be kept out
of reach of children and disposed
in accordance whit the national
regulations for waste processing.
Do not modify or disassemble the
appliance. Do not remove the ceramic
heater. It may cause re, electric shock
or injury.
This appliance is designed and produced
for home use only and is not suitable for
installing and using in public places or on
vehicles, boats or aircraft.
BEFORE USING
THE PRODUCT
Use a single-phase alternating current
230 V, 50 Hz power supply. Voltage
in excess of 230 V +10 % may cause
malfunction, so stay within the rated
range.
Electrical wiring work should be done by
a certied professional in conformance
with local standards.
Be sure to install a ground-fault circuit
interrupter with idn < 3 mA
This is a CLASS I electric insulation
appliance and must be properly
grounded.
Iftheelectriccable orthe plugare damaged
and has to be repaired do not perform
this repair by yourself. Bring the product to
a qualied repair centre and have them
repaired by specialised personnel in order
to avoid any risk of damage.
FOR YOUR
SAFETY
Never use the product in rooms that are
saturated with explosive gas, vapours
generated by solvents or paints or any
other ammable vapours or gas.
This appliance is not intended for use
by young people or by persons who
possess limited physical, sensorial or
mental capabilities unless they are
adequately supervised by a responsible
person to ensure that they can use the
appliance safely. Young children should
be supervised to ensure that they do not
play with the appliance.
Never allows animals or children to play
with or touch the appliance.
Attention! When turned on, the panel
may become very hot (about 80 °C).
Attention this appliance is intended only
for drying textiles washed in water.
Never leave your home while the
appliance is turned on; make sure the
illuminated switch is OFF and the red
light is off.
Never install the appliance on a surface
made of wood or synthetic material.
Always place this appliance in vertical
position so that the switch results on the
down side of it.
Do not climb on the appliance.
Never place this appliance immediately
underneath a power socket.
Always make observe the minimum
distances from wall, furniture or other
objects as showed (g. A).
The appliance has a grade IPX4 water
protection. The product may be used in
bathrooms or humid places as long as the
safety zones are respected. In any cases
avoid installing the appliance in location
where there is a lot of condensation.
It must never be possible for person in the bath
tub or shower to reach the power switch.
SAFE
POSITIONING
INSTRUCTION FOR USE

The product must be powered at a
voltage of 230 Vac, 50 Hz.
The product is supplied, depending
on type, with a Schuko plug cable to
connect to a proper socket, or with a 3
core cable for a permanent installation
to the main power supply (Brown = Live,
Blue = Neutral, Green/Yellow = Earth
). ).
Expansion plugs and screws, provided
with the product, are only suitable for
concrete or solid brick walls. For different
wall material types, use the appropriate
xing means.
INSTALLATION
ELECTRICAL
CONNECTIONS
By means of the illuminated switch the
radiator can be switched on and off.
USE OF THE PRODUCT
Clean the wood parts with a clean damp
cloth.
Avoid using acid-based product on
painted metallic parts. Do not use
products containing sodium hypochlorite,
chlorinebased detergents, or those
containing bleach or aggressive solvents
that are not suitable for the cleaning of
painted surfaces. Do not use abrasive
sponges.
CLEANING
9
INSTRUCTION FOR USE
ENVIRONMENT AND RECYCLING
Please help us to protect the environment by
disposing the packaging in accordance with the
national regulations for waste.
Recycling of obsolete appliances
Appliances with this label must not be disposed of in
general waste. The disposal of use equipment must
be performed in conformity with to local regulations.
In the event of overheating, the safety
internal device automatically detaches
the ceramic heater element. The radiator
will start again to operate as soon as the
temperature returns below the safety
threshold.
If malfunction operating is
noted or the damaging of the
panel appear, disconnect the
radiator from the main supply
and contact the dealer.
MALFUNCTION EVENT

Via Praglia, 15 - 10044 Pianezza (TO) - Italy
tel./ fax [phone]
www.homwarm.com - [e-mail]