homechoice Buhle Compactum User manual

Buhle Compactum
assembly instruction
Shop online – go to
homechoice.co.za
Please follow these guidelines for safe assembly:
Please make sure that you have all the parts and hardware items listed before you start
assembling your product. If you nd that something is missing, please do not assemble.
Contact our Customer Service on 0861 466 324.
HomeChoice will not be held liable for damages caused by improper assembly.

Assembly Instructions
3cm
Step 1 Step 2 Step 3
Move the compactum away
from the wall and then mark
a spot about 3cm below your
original mark. (Again, it does
not need to be exact as there
is some leeway.)
Mark a spot on the wall at the
level of the top, above the clip.
(It does not need to be exact as
there is a bit of leeway.)
Place the compactum against
the wall where you want it to
go. If the wall is drywall, the
centre of the compactum
needs to be at a stud. (A stud
is the wood that supports the
drywall.)
Part Pieces
15mm black nylon P-Clip 1 piece
2Nylon wall plug
Self tapping screw 1 piece
3Drywall screw 1 piece
4Black cable tie 1 piece
Parts List

If you nd that something is missing, please contact our Customer Service on 0861 466 324.
Step 4 Step 5 Step 6
Step 7 Step 8 Step 9
ONLY DO THIS IF YOU HAVE A
BRICK OR CONCRETE WALL.
Using a 6mm masonry drill bit,
drill on the LOWER X to the
depth of the wall plug length.
ONLY DO THIS IF YOU HAVE A
BRICK OR CONCRETE WALL.
Insert wall plug into the wall.
Make sure it goes in all the way.
ONLY DO THIS IF YOU HAVE A
BRICK OR CONCRETE WALL.
Using the silver screw, attach
the clip to the wall.
Insert the pointed end of the
cable into the locking piece
and pull through to tighen the
cable tie. Repeatedly push the
compactum closer to the wall,
and tighten the cable tie until
the compactum is close to the
wall.
Move the compactum back,
close to the wall (about 10cm),
leaving enough gap to work.
Thread the cable tie through
both clips.
ONLY DO THIS IF YOU HAVE A
WOOD OR DRY WALL.
Using the black screw, attach
the clip to the wall at the lower
X mark.
NOTE: Partial tipping of the unit is normal (a few centimeters) but the unit should not
be able to fall on the child. After installation, tug on the ttings rmly to ensure correct
installation.
Drill on lower
mark

Care and maintenance of furniture:
IMPORTANT:
Congratultaions on your little one!! Carefully read through this manual and follow each
step to ensure a safe experience for your child.
• Warning: To prevent possible serious injury or death should your child be able to climb,
ensure that you properly ax the compactum to the wall and do not place it too close
to a window, blind cords, curtain pulls or other cords and furniture, etc.
• Warning: Do not use if any part is broken, torn or missing and use only spare parts
approved by the manufacturer.
• Warning: Be aware of the risk of open res and other sources of strong heat, such as
electric bar res, gas res or electrical plugs near wooden furniture.
• All assembly ttings should be tightened properly and should be checked regularly and
re-tightened as necessary.
• Your furniture can be cleaned by wiping with a damp cloth and drying with a soft clean
cloth.
• Do not use abrasives, bleach, alcohol or ammonia-based household polishes.
Installation tools required but not supplied
• Medium Phillips star screwdriver
If you are xing to a brick wall:
• Electric drill with hammer function
• 6mm Masonry Drill bit
Please recycle the packaging to protect the environment