HoMedics AR-75 Instruction Manual

Instruction Manual and
Warranty Information AR-75
Professional HEPA
Air Cleaner
2

2
IMPORTANT SAFETY INSTRUCTIONS:
WHEN USING ELECTRICAL PRODUCTS, ESPECIALLY WHEN CHILDREN ARE
PRESENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED,
INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS BEFORE USING
DANGER – TO REDUCE THE RISK OF ELECTRIC SHOCK:
• Always unplug the air cleaner from the electrical outlet immediately after using and
before cleaning.
• Keep cord away from heated surfaces
• Always place the air cleaner on a firm, level surface.
• Always place the air cleaner at least 15cm away from walls and one (1) metre
from heat sources such as stoves, radiators, or heaters.
• DO NOT operate where aerosol (spray) products are being used or where oxygen is
being administered.
• DO NOT reach for an appliance that has fallen into water. Unplug it immediately.
• DO NOT use while bathing or in the shower.
• DO NOT place or store appliance where it can fall or be pulled into a tub or sink.
• DO NOT place in or drop into water or other liquid.
• NEVER use pins or other metallic fasteners with this appliance.
• Keep dry - DO NOT operate in a wet or moist condition.
• This appliance is designed for personal, non-professional use only.

3
• Check your air cleaner cord and plug connections.
• Faulty wall outlet connections or loose plugs can cause the outlet or plug to
overheat. Be sure the plug fits tight in the outlet.
CAUTION: It is normal for the plug to feel warm to the touch; however,
a loose fit between the AC outlet (receptacle) and plug may cause
overheating and distortion of the plug. Contact a qualified electrician
to replace loose or worn outlet.
WARNING - TO REDUCE THE RISK OF BURNS, FIRE, ELECTRIC
SHOCK OR INJURY TO PERSONS:
• Extreme caution is necessary when any air cleaner is used by or near children or
invalids and whenever the air cleaner is left operating and unattended.
• Always unplug the air cleaner when not in use.
• Do not operate the air cleaner with a damaged cord or plug, or after the air cleaner
malfunctions, has been dropped or damaged in any manner. Discard the air cleaner
or return to HoMedics Consumer Relations for examination, electrical or mechanical
adjustment, or repair.
• This air cleaner is not intended for use in bathroom, laundry areas and similar moist
indoor locations. Never locate air cleaner where it may fall into a bathtub or other
water container.
• Do not run cord under carpeting. Do not cover cord with throw rugs, runners or
similar coverings. Do not route cord under furniture or appliances. Arrange cord
away from traffic areas where it can be tripped over.
• To disconnect the air cleaner, first turn controls to the OFF position, then remove
plug from outlet.
• Do not tilt or move the air cleaner while it is in operation. Shut off and remove plug
from outlet before moving.
• Do not insert or allow foreign objects to enter any ventilation or exhaust opening as
this may cause an electric shock or fire, or damage the air cleaner.
• To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not
use on soft surface, like a bed, where openings may become blocked.

4
• Use this air cleaner only for its intended use as described in this manual. Any other
use not recommended by the manufacturer may cause fire, electric shock, or injury
to persons.
• Always plug the air cleaner directly into a wall outlet/receptacle. Never use with an
extension cord or relocate power tap (outlet/power strip).
• DO NOT use outdoors.
• The appliance is not intended for use by young children or infirmed persons without
supervision.
• Young children should be supervised to ensure that they do not play with the
appliance.
SAVE THESE IMPORTANT INSTRUCTIONS FOR EASY REFERENCE
Technical Specifications
Input voltage 240 V
Rated Frequency 50 HZ
Power 48 Watts
Weight 3.9 kgs
Noise Level <60 dB
Unit Height 34.3cm

5
Main Features on the Professional HEPA Air Cleaner
Control Panel
Main Unit
HEPA Filter Front Grill Plate

6
CLEAN FILTER
1 2 3
Clean Filter Indicator
Speed Selection (Low/Medium/High)
Power ON/OFF Control

7
Operating Instructions
Turning the Unit On
• Take the air cleaner out of the box and remove the clear protective plastic bag.
• Place the air cleaner on a firm level surface.
• Before turning the air cleaner ON, you need to confirm that the filter is firmly in place
and did not become loose during shipping.
1. To check filter, open the front grill by
gently pulling on the tabs on either side
of the top of the grill plate.
2. Open the plate outward until the tabs at
the bottom of the grill plate easily slide
away from the unit.
Fig. 1
Fig. 2

8
3. The HEPA filter will be resting inside the
unit. Make sure that the filter is firmly
seated inside of the unit.
4. Place the tabs at the bottom of the
grill plate into the base of the unit.
Gently push the grill plate back into place
until you hear a click sound indicating
that the grill is firmly latched.
Connect the power cord into a standard
240V AC outlet.
1. On/Off and Speed Settings
• To turn the air cleaner on, press the ON/OFF button on the control panel.
When the air cleaner is on, the LED light in the ON/OFF button on the control
panel will be lit and the air cleaner will start to operate on LOW speed.
• Once the air cleaner is ON, slide the SPEED selector bar to select
speed settings.
• To turn the air cleaner OFF, simply press the ON/OFF button on the
control panel.
Cleaning and Maintenance
We recommend that the air cleaner be cleaned at least once a month and before
storage.
• Turn the air cleaner OFF at the main switch and unplug it from the outlet.
• Use a dry cloth to clean the external surfaces of the air cleaner.
• The grill plate may be cleaned with a damp cloth or the brush attachment of your
vacuum cleaner.
Fig. 3
Fig. 4

9
DO NOT USE WATER, WAX, POLISH OR ANY CHEMICAL SOLUTION
Clean Filter Indicator
The air cleaner is equipped with a CLEAN FILTER indicator to let the user know when
it is time to clean the HEPA filter, about every 2160 (90 days) hours of use. When the
HEPA filter is ready to be cleaned, the LED CLEAN FILTER indicator will light up on the
control panel.
Once the HEPA filter has been cleaned, press and hold the CLEAN FILTER button to
reset the Indicator until the LED indicator light flashes and turns off.
Cleaning the HEPA Filter
Make sure that the air cleaner is turned OFF and unplugged from the outlet before
cleaning.
1. Open the front grill by gently pulling on
the tabs on either side of the top of the
grill plate.
2. Open the plate outward until the tabs
at the bottom of the grill plate easily
slide away from the unit.
Fig. 5
Fig. 6

1 0
3. Remove the HEPA filter from the main
unit.
4. Use the brush attachment with your
vacuum cleaner. Run the attachment
along both sides of the HEPA filter,
cleaning thoroughly between the
accordion folds of the filter.
5. Place the clean HEPA filter back in the
main unit, making sure that it is firmly
seated inside the unit.
Fig. 7
Fig. 8
Fig. 9