HoMedics AR-OTSC Instruction Manual

Instruction Manual and
Warranty Information AR-OTSC
El manual en español
empieza a la página15
P
l
e
a
s
e
T
a
k
e
A
M
o
m
e
n
t
N
o
w
Register
Your Product At:
www.homedics.com/register
Your valuable input regarding this
product will help us create
the products you will
want in the future.
Oscillating
Tower
Air Cleaner

2
IMPORTANT SAFETY INSTRUCTIONS:
WHEN USING ELECTRICAL PRODUCTS, ESPECIALLY WHEN CHILDREN ARE
PRESENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED,
INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS BEFORE USING
DANGER – TO REDUCE THE RISK OF ELECTRIC SHOCK:
• Always unplug the air cleaner from the electrical outlet immediately after using and
before cleaning.
• Keep cord away from heated surfaces.
• Always place the air cleaner on a firm, level surface.
• Always place the air cleaner at least six (6) inches away from walls and three (3) feet
from heat sources such as stoves, radiators, or heaters.
• DO NOT operate where aerosol (spray) products are being used or where oxygen is
being administered.
• DO NOT reach for an appliance that has fallen into water. Unplug it immediately.
• DO NOT place or store appliance where it can fall or be pulled into a tub or sink.
• DO NOT place in or drop into water or other liquid.
• Keep dry - DO NOT operate in wet or moist conditions.
• Check your air cleaner cord and plug connections. Faulty wall outlet connections or
loose plugs can cause the outlet or plug to overheat. Be sure the plug fits tight in the
outlet.

3
WARNING - TO REDUCE THE RISK OF BURNS, FIRE, ELECTRIC
SHOCK OR INJURY TO PERSONS:
• Extreme caution is necessary when any air cleaner is used by or near children or
invalids and whenever the air cleaner is left operating and unattended.
• Always unplug the air cleaner when not in use.
• Do not operate the air cleaner with a damaged cord or plug, or after the air cleaner
malfunctions, has been dropped or damaged in any manner. Return to HoMedics
Consumer Relations for examination, electrical or mechanical adjustment, or repair.
• This air cleaner is not intended for use in bathroom, laundry areas and similar moist
indoor locations. Never locate air cleaner where it may fall into a bathtub or other
water container.
• Do not run cord under carpeting. Do not cover cord with throw rugs, runners or
similar coverings. Do not route cord under furniture or appliances. Arrange cord
away from traffic areas where it can be tripped over.
• To disconnect the air cleaner, first turn controls to the OFF position, then remove
plug from outlet.
• Do not tilt or move the air cleaner while it is in operation. Shut off and remove plug
from outlet before moving.
• Do not insert or allow foreign objects to enter any ventilation or exhaust opening as
this may cause an electric shock or fire, or damage the air cleaner.
• To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not
use on any soft surface, like a bed, where openings may become blocked.
• Use this air cleaner only for its intended use as described in this manual. Any other
use not recommended by the manufacturer may cause fire, electric shock, or injury
to persons.
• DO NOT use outdoors.

4
SAVE THESE IMPORTANT INSTRUCTIONS FOR EASY REFERENCE
Technical Specifications
Input voltage 120 V
Rated Frequency 60 HZ
Power 60 Watts
Weight 12.5 lbs
Noise Level <60 dB
Unit Height 28"
This product earned the ENERGY STAR by meeting strict energy
efficiency guidelines set by the US EPA. US EPA does not endorse
any manufacturer claims of healthier indoor air from the use of this
product.
The energy efficiency of this ENERGY STAR qualified model is
measured based on a ratio between the model’s CADR for Dust
and the electrical energy it consumes, or CADR/Watt.

5
Main Features of the HoMedics Tower Air Cleaner
Control Panel
Main Unit Rear Grill
HEPA Filters
Pre-Filter

6
NOTE: This appliance has a polarized plug (one blade is wider than
the other). To reduce the risk of shock, this plug is intended to fit only
one way in a polarized outlet. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician.
DO NOT attempt to defeat this safety feature. To do so could result in
an electric shock hazard.
Control Panel
Fan
Speed
Fan
Speed
Control
Power
On/Off
Timer
Control
Timer
Screen
Oscillation
On/Off
Clean/Reset
Filter Indicator
Button

7
Operating Instructions
Turning the Unit On
• Take the air cleaner out of the box and remove the clear protective plastic bag.
• Place the air cleaner on a firm level surface.
• Before turning the air cleaner ON, you need to confirm that the filters are firmly in
place and did not become loose during shipping.
1. To check filters, open the rear grill
by gently pushing down on the
release tab on the top of the rear
grill. Fig. 1
2. Open the grill outward until the
tabs at the bottom of the grill
easily slide away from the
unit. Fig. 2
3. The HEPA filters will be resting
inside the unit. Make sure that the
filters are firmly seated inside the
unit. Fig. 3
Fig. 1
Fig. 2
Fig. 3

8
4. Place the tabs at the bottom of
the grill into the base of the unit.
Gently push the grill back into
place until you hear a click sound
indicating that the grill is firmly
latched. Fig. 4
Plug the power cord into a
standard AC outlet.
NOTE: Unit will not operate unless filters and grill are properly installed.
1. On/Off and Speed Settings
• To turn the air cleaner on, press the ON/OFF button on the control panel.
When the air cleaner is on, the ON/OFF button on the control panel will be lit and
the air cleaner will start to operate on LOW speed.
• Once the air cleaner is ON, press the SPEED+ button to increase the fan speed to
the MED. setting. Press again to increase the fan speed to HIGH setting. To
decrease the fan speed, press the SPEED– button until your desired setting is
reached. The fan speed setting is indicated by the illuminated ring around the
fan icon.
• To turn the air cleaner OFF, simply press the ON/OFF button on the
control panel.
2. Timer
There are four possible timer settings: 2 (two) hours, 4 (four) hours, 8 (eight) hours, and
12 (twelve) hours. To activate the timer press the TIMER+ button on the control panel.
Each time the + button is pressed, it will display the successive settings. To return to
a setting already passed, press the TIMER– button. Once a timer setting has been
selected, it will remain displayed on the TIMER screen. To operate continuously, cycle
down through all timer settings until no timer setting is displayed.
Fig. 4

9
3. Oscillation
To activate the oscillation feature, press the button. To stop oscillation, press the
button a second time. Unit will not automatically realign with foot when oscillation is
stopped. To achieve alignment, stop oscillation at the moment the body becomes
aligned with the foot.
Cleaning and Maintenance
We recommend that the air cleaner be cleaned at least once a month and before
storage.
• Turn the air cleaner OFF at the main switch and unplug it from the outlet.
• Use a dry cloth to clean the external surfaces of the air cleaner.
• The grill plate may be cleaned with a damp cloth or the brush attachment of your
vacuum cleaner.
NEVER USE WATER, WAX, POLISH OR ANY CHEMICAL SOLUTION TO
CLEAN THE GRILL OR THE OUTSIDE OF THE UNIT

10
Cleaning the HEPA Filters
Make sure that the air cleaner is turned OFF and unplugged from the outlet before
cleaning.
1. Open the rear grill by gently pushing
down on the tab on the top of the
grill. Fig. 5
2. Open the grill outward until the tabs
at the bottom of the grill easily slide
away from the unit. Fig. 6
3. Remove the HEPA filters from the
main unit. Fig. 7
Note: There are two HEPA filters in
this air cleaner
4. Use the brush attachment with
your vacuum cleaner. Run the
attachment along both sides of
the HEPA filters, cleaning thoroughly
between the accordion folds of the
filters. Fig. 8
Fig. 5
Fig. 6
Fig. 7
Fig. 8