Honeywell HWM-4000 Series User manual

OWNER’S MANUAL
•
•
•
•••
•
3 US GALLONS (10.2 LITERS) OUTPUT PER DAY
WARM MOISTURE HUMIDIFIER
Model HWM-4000 Series
* Output dependent on room temperature and humidity.
*

READ AND SAVE THESE SAFETY INSTRUCTIONS BEFORE USING THIS HUMIDIFIER
When using electrical appliances, basic precautions should always be followed to
reduce the risk of fire, electric shock, and injury to persons, including the following:
1. Always place this humidifier on a firm, flat and level surface. This humidifier may
not work properly on an uneven surface.
2. CAUTION: To reduce the risk of burns, place this humidifier in an area where it is
not accessible to children.
3. Do not place the humidifier near any heat sources such as stoves, radiators, and
heaters.
4. Before using the humidifier, check the power cord for any signs of damage. If the
cord is found to be damaged, DO NOT USE and return the humidifier to the manu-
facturer under the warranty agreement for repair.
5. This appliance has a polarized plug (one blade is wider than the other). To reduce
the risk of shock, this plug is intended to fit only one way in a polarized outlet. If
the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, con-
tact a qualified electrician. DO NOT attempt to defeat this safety feature.
6. To disconnect the humidifier, first turn controls to the OFF position, then grip the
plug and pull it from the wall outlet. Never pull by the cord.
7. A loose fit between the AC outlet (receptacle) and plug may cause overheating
and a distortion of the plug. Contact a qualified electrician to replace loose or
worn outlet.
8. The humidifier should always be unplugged and emptied when not in operation
or while being serviced or cleaned.
9. Never tilt or attempt to move the humidifier while it is operating or filled with
water. UNPLUG the humidifier before moving.
10. This humidifier requires regular cleaning. Refer to the CLEANING instructions
provided. Never clean the humidifier in any manner other than as instructed in
this manual.
11. Turn the humidifier OFF if the relative humidity exceeds 60%, or if you notice
moisture on the inside of your windows. For proper humidity reading use a
hygrometer, which is available in many hardware and department stores or by
ordering one from Honeywell. (See CARE PRODUCTS).
12. DO NOT touch the steam vapor. Steam can cause burns.
IMPORTANT SAFETY INSTRUCTIONS

INTRODUCTION
Thank you for purchasing a Honeywell Warm Moisture
Humidifier. If you would like more information on our full line of
products, visit our website at: www.honeywell.com/yourhome.
HOW DOES IT WORK?
Water passes into the Power Unit where it is heated and purified. The Warm
Moisture system then pulls the air through the top vent and spreads invisible
moisture-balanced air into the room.
MODEL HWM-4000
Your humidifier is made up of these parts:
Water Tank
Power Unit
Base
Fill Cap
Dishwasher Safe
Medicine Cup Grille
Removable
Tray

• Remove the water tank by grasping the handle and
pulling straight up. Set aside (Fig. 1).
• Turn the Water Tank upside down so that the Fill Cap
is facing up; unscrew the Fill Cap by turning it
counter-clockwise and set aside.
•
Fill the Water Tank with COOL tap water (Fig. 2).
Distilled water is not necessary as the water is purified
by the heating element.
DO NOT USE HOT WATER.
Doing so may damage the humidifier.
•Replace the fill cap by turning it clockwise . DO
NOT OVER TIGHTEN.
NOTE: WHEN CARRYING THE FILLED WATER TANK,
PLEASE USE THE HANDLE AND PLACE YOUR OTHER
HAND UNDER THE TANK FOR ADDITIONAL SUPPORT.
•Turn the Water Tank right side up.
•Position the Water Tank into the humidifier and push
it into place (Fig. 3).
•Some water will flow into the Removable Tray when
the filled tank is properly in place.
•Once the filled tank has been positioned, do not
attempt to move the humidifier. If it has to be moved,
unplug the humidifier and remove the water tank first.
CAUTION: DO NOT POUR WATER INTO THE GRILLE ON
TOP OF THE HUMIDIFIER (Fig. 3). DOING SO MAY DAM-
AGE THE HUMIDIFIER OR CAUSE PERSONAL INJURY.
SET UP
NOTE: We recommend that the humidifier be disinfected prior to first use. Please
see WEEKLY CLEANING instructions.
•Select a firm, level, flat location - at least six inches (15 cm) from any wall for
proper air flow (Fig. 1). Place the humidifier on a water-resistant surface, as
water can damage furniture and some flooring.
Honeywell will not accept responsibility for property damage caused by water
FILLING
Refill& Restart
M
o
i
s
t
u
r
e
C
o
n
t
r
o
l
Desired
Humidity
Refill&
Restart
Power
Low
High
Off
•
•
•
•••
•
Fig.1
➡
Fig.2
•
•
•
•••
•
Fig.3
WALL
6"
Grille
spillage.

POWER
CAUTION: DO NOT PLUG IN THE HUMIDIFIER WITH WET HANDS AS AN
ELECTRICAL SHOCK COULD OCCUR.
•With the Power knob in the OFF position, plug the filled humidifier into a
polarized 120V outlet. DO NOT FORCE THE POLARIZED PLUG INTO THE OUTLET;
it will only fit one way.
HUMIDITY CONTROL
1. Set the Power knob to the desired position (Fig. 4).
HIGH: For fast humidifying
LOW: For more gradual humidification
NOTE: You will not hear a difference when turning
the humidifier from High to Low.
2. Set the Humidistat on high, by turning the Moisture
Control counter-clockwise to the “+”setting.
NOTE: If the humidifier will not start or restart when
you select a power setting, the Humidistat may be
set too low. Turn the Moisture Control counter-
clockwise to the largest black dot before the
“+”sign. The Desired Humidity light will be OFF
when the unit is producing moisture (Fig. 4).
3. Press down and release the Start lever. This will
start the humidifier.
NOTE: Allow 5-10 minutes for the humidifier to begin producing moisture.
OPERATION
•
•
•
•••
•
Fig.4
(press)
(High) (Low)

FEATURES
HUMIDISTAT
The Humidistat (Moisture Control knob) allows you to adjust and select the humidity
level to your personal preference. Your humidifier will turn on and off throughout the
day and night to maintain the Desired Humidity level you have selected.
SETTING THE MOISTURE CONTROL/HUMIDISTAT
First run the humidifier per the operation instruction with
the Moisture Control set to its highest setting, to the “+”
sign (Fig. 4).
•Let the humidifier run on high for at least one hour or
until your room has reached a comfortable humidity
level.
•At this point, slowly turn your Humidity Level knob
clockwise until the humidifier shuts off, and the
Desired Humidity light comes on (Fig. 5).
•Now that your humidistat is set, the humidifier will
automatically turn back on when your room drops
below your comfort setting and will automatically turn
off again when the setting is reached.
If condensation begins to form on the walls or windows,
AUTO SHUT OFF FEATURE/REFILL LIGHT
•The humidifier will turn off when both the Base and Water Tank are empty. The
Refill light will glow to let you know your humidifier is empty.
•Refill the tank per the FILLING instructions.
IMPORTANT
• Press down and release the Start lever. This will start the humidifier and turn off
the Refill light.
• THE Start LEVER MUST BE PRESSED AFTER REFILLING THE WATER TANK TO
START THE HUMIDIFIER.
•
•
•
•••
•
Fig.5
lower the Moisture Control setting.
(press)

FEATURES CONTINUED
MEDICINE CUP
A medicated vapor can be distributed into the air by using the Medicine Cup at the
top of the Power Unit (Fig. 6).
TO ADD MEDICINE TO THE MEDICINE CUP
1. Turn the humidifier OFF and allow at least 10 minutes for the unit to cool.
2. Lift the Grille from the Power Unit to access the Medicine Cup (Fig. 6).
3. Remove the Medicine Cup from the Power Unit.
4. Fill the cup halfway with liquid medicine.
5. Carefully place Medicine Cup back into the Power Unit and put the Grille back
in place.
6. After use, remove the Medicine Cup and clean with warm water or in the dish
washer. Replace the clean, dry Medicine Cup into the Power Unit.
WARNING: DO NOT use any liquid medicines other than those specifically recom-
mended for use with a steam vaporizer or warm humidifier. DO NOT pour medicine
directly through the Grille opening or add it to the Water Tank.
Honeywell assumes no responsibility for consequences resulting from the uses of
medicine in this humidifier.
••
•
•
•
•
Fig.6 Grille
Medicine Cup
Place
medicine
here

WEEKLY CLEANING
We recommend cleaning the humidifier weekly, more often if you have hard water
or notice a build-up of impurities or detect unpleasant odors.
Cleaning involves two steps SCALE REMOVAL and DISINFECTING. Be sure to
perform these in the proper order to avoid harmful chemical interactions.
•First, turn off and unplug the humidifier. Wait at least
10 minutes for the unit to cool.
•Remove the Water Tank.
•To remove the Power Unit, pull the Latch to release
(found under the Water Tank) and lift the Power Unit
(Fig. 7). Turn upside-down to check condition of heating
element. If build-up of minerals is heavy, follow the
CLEANING THE HEATING ELEMENT instructions. Set
the Power Unit aside.
•Empty any remaining water from the Base and Removable Tray.
STEP ONE:
SCALE REMOVAL
REMOVABLE TRAY:
1. Fill the Removable Tray with either:
•1 cup (8ozs) undiluted white vinegar
or
•Use DuraRinse®Humidifier Cleaner,
part no. AC-816, following bottle
instructions.
2. Let solution stand for 20 minutes.
3. With the vinegar or DuraRinse®in the
Removable Tray clean all interior sur-
faces with a soft cloth or brush to
help remove scale.
4. Rinse the Removable Tray thoroughly
with water to remove scale and
cleaning solution.
STEP TWO:
DISINFECTING
WATER TANK/REMOVABLE TRAY:
1. Fill the Water Tank with:
•1 teaspoon of household bleach
and
•1 gallon of water.
Pour some of this solution into the
Removable Tray.
2. Let solution stand for 20 minutes.
3. Rinse with water until the odor of
bleach is gone.
NOTE: THE USE OF OTHER WATER TREAT-
MENT PRODUCTS, CHEMICALS, SOAPS,
DETERGENTS OR ABRASIVE CLEANSERS
NOT RECOMMENDED IN THE MANUAL
MAY CAUSE DAMAGE TO THE HUMIDIF-
IER OR AFFECT PERFORMANCE.
Fig.7 Latch
Removable
Tray
Base

CLEANING THE HEATING ELEMENT
If the output drops, or the Refill light remains on, even while there is water in the
tank, the mineral build-up may need to be removed from the heating element of the
Power Unit.
How often you perform this special maintenance depends upon the hardness of the
water you are using and how quickly mineral deposits form on the interior surfaces
of the humidifier.
1. Turn off and unplug the humidifier. Allow at least 10 minutes for the unit to cool.
2. The heating element is on the bottom of the Power
Unit. To access it, remove the Power Unit by pulling on
the Latch (found under the Water Tank) and lifting the
Power Unit (Fig. 7).
3. Turn it upside down. BE SURE IT HAS COOLED
SUFFICIENTLY.
4. Use a non-metallic brush or a soft, dry cloth to wipe
the outer surfaces of the heating element (Fig. 8). Some
deposit may remain, but should not interfere with the operation of the unit.
5. DO NOT clean the heating element under running water. Doing so may cause
damage or personal injury.
END-OF-THE-SEASON CARE AND STORAGE
•Follow WEEKLY CLEANING instructions when the humidifier will not be used for at
least one week or more, or at the end of the season.
•Dry the humidifier completely before storing. DO NOT store with water inside the
Removable Tray, Base, or Water Tank.
•Pack the unit in its original carton and store in a cool, dry location.
•Before next use, remember to clean the humidifier.
Fig.8
Heating
Element

TROUBLE SHOOTING
Q: The humidifier is not running, but all (or some) of the lights are on.
A: If the Desired Humidity light is ON: The Moisture Control may be set too low.
Moving the Moisture Control counter-clockwise to the highest setting
should restart the unit.
If the Refill light is ON: The humidifier is out of water. Refill the Water Tank and
press the Start lever and the humidifier should restart.
Q: The Moisture Control was set according to the manual, but the humidifier never
seems to turn back on. Is something wrong?
A: The Moisture Control may be set too low. Moving the Moisture Control clock-
wise to the highest setting should restart the unit. Reset the Moisture
Control following the instructions under FEATURES.
Q: The Moisture Control was set according to the manual, but the humidifier never
seems to turn off. Is something wrong?
A: The Moisture Control may be set too high. Reset the control following the
instructions under FEATURES.
Q: My humidifier is filled with water, but the Refill light is still on. What’s wrong?
A: First, be sure to press down once on the Start lever. If this doesn’t help, refer to
the CLEANING THE HEATING ELEMENT instructions for the heating element.
Q: When I turn the humidifier from high to low there is no difference in sound. Is
the unit operating correctly?
A: Yes, the unit is operating normally. The High/Low control varies the temperature
of the heating element and therefore there will be no difference in sound.