Hooker Furniture 1652-75410-MWD User manual

1/2
ASSEMBLY INSTRUCTION
Item#: 1652-75410-MWD Upholstered Side Chair
** Please make sure you have all parts indicated below prior to assembly.
Diagram 2 Diagram 1
Assembly Steps:
There are two K/D chairs in one box. Please follow numbers on one chair and letters on the other
chair during assembly.
1. Place chair back (F) on a clean surface.
2. Tighten seat frame (G) to chair back (F) by using bolt (C), lock washer (B) and flat washer
(A) at the center location. (See diagram 2). Then, tighten the corners of seat frame (G) to
chair back (F) by using 4 bolts (E), 4 lock washers (B) and 4 flat washers (A). (See
diagram 1)
3. Assemble two front legs with front corner blocks of seat frame (G), using 4 bolts (C), 4 lock
washers (B) and 4 flat washers (A). Tighten all bolts by hand. (See diagram 2)

2/2
4. After all bolts are attached and hand tightened, turn the chair upright.
5. Level the chair following the “chair leveling instruction” as below.
6. Make sure the chair is level and then tighten all bolts completely by using the allen wrench
(D).
PLEASE READ THESE INSTRUCTIONS PRIOR TO ASSEMBLING THE CHAIRS
CHAIR LEVELING INSTRUCTION SUPPLEMENT
Chair leveling procedures:
To make the assembly process easy and efficient, please read the entire instruction sheet
prior to assembling of the chair. Make sure all hardware listed is included. To properly
assemble the chair, none of the bolts should be fully tightened until all components are
attached to the chair. This will allow an opportunity to level the chair and prevent any
unnecessary “rocking”.
1. Place the loosely assembled chair on a hard flat surface.
2. Apply gentle downward pressure on the seat. This step eliminates rocking and
ensures the chair will be level.
3. Once the chair is level, tighten all bolts and nuts.
Note:
Most floors have slight irregularities that can affect chair leveling. If your chair is
uneven when placed in its desired location, perform the following steps:
1. Loosen front legs to finger tight.
2. Extend both front legs to their fullest length.
3. Gently push downward on the front edge of the seat until all four legs rest on the floor.
4. Re-tighten all bolts and nuts.
Cleaning Instruction: Clean finished parts with a damp cloth using a mild dishwashing liquid and water solution.
Polish the finish with soft cloth and an industry recognized furniture polish.