Hooker Furniture EC289 User manual

EC289 Assembling Instruction
(Pic for reference only)
Carefully unpack all parts and identify them with parts list and
assemble the chair following the Assembly Instructions.
Put the chair onto a flat floor then you can sit onto and adjust the
reclining and the seat height
1. Please sit down onto the chair and use the left handle (A) to adjust the
reclining of the chair, and use the right handle (B) to adjust the height of
it.
2. Pull the left handle (A) out and the chair is active to recline. Get a
desired tilt and release the left handle to lock it. You can lock at several
different tilt angles by reclining your body.
3. Turn the right handle (B) upward to activate the cylinder for adjusting
the height of the chair. Raise your body up, the seat will be lifted up to a
desired height by the cylinder. To get a lower height, please sit down
with the right handle (B) turning upward. Release the right handle (B) to
lock the cylinder when you achieve a desired seat height.
4. Turn the knob (C) clockwise to lessen the tension and counter
clockwise to tighten the tension
Parts As Shown
A. Left handle--for reclining
B. Right handle—for adjusting seat height
C. Tilt tension knob

D. Base set
EC289 Assembling Instruction
(Pic for reference only)
Carefully unpack all parts and identify them with parts list before
attempting to assemble the chair.
IMPORTANT: DO NOT TIGHTEN BOLTS AND SCREWS FULLY UNTIL
YOU HAVE COMPLETED THE FINAL ASSEMBLY.
!"

1. Carefully remove the 5 STAR BASE (B) from the carton. The base is
located behind the fiberboard that is behind the chair UNIT
SEATING(G).
2. Put 5 CASTERS (A) into the holes of 5 STAR BASE (B).
3. Insert GAS LIFT (C) to the center hole top of 5 STAR BASE (B), and
put the BELLOWS (D) onto the GAS LIFT(C).
4. Attach SEAT PLATE (F) to the Unit Seating (G) by using 4 SCREWS
(E) with 4 FLAT WASHERS (E1).
5. Insert the pre-assembled seat unit onto the gas lift to finish the final
assembly.
6. Be sure that all the screws are fully tightened before using.
Parts List
A. CASTERS
5
B. 5 STAR BASE
1
C. GAS LIFT
1
D. BELLOWS
1
E. SCREWS (5/16”x1-1/4”)
E1. FLAT WASHERS
4
4
F. SEAT PLATE
1
G. UNIT SEATING
H. ALLEN KEY
1
1