Hornby Hobbies SCALEXTRIC Setup guide

Hornby Hobbies Ltd, 3rd Floor, The Gateway, Innovation Way, Discovery Park, Sandwich, CT13 9FF
PI-00749T

Insert the plug on the wall mounted transformer into the socket on the Powerbase. Switch on
the power at the wall socket. Bind controllers to corresponding lanes (Red and Green).
Attach lanyard to the bottom of the controller and loop around wrist for added security
whilst racing.
To get you started, follow the numbered illustrations to assemble the layout, using the
circuit diagram as a guide.
! If track clicks have attened during storage, adjust as shown in 1a to esure that they are fully
engaged when assembled.
Add the track supports under the track (if required) in the positions indicated on the track
diagrams.
Place the cars onto the track ensuring that their guide blades are located fully in the track slots.
To race, gently squeeze the trigger on the hand controler to accelerate along the straights
and release the trigger to slow down for the curves. The further the trigger is squeezed the
faster the car will go.
Track Reference codes shown on the track diagrams are marked on the underside of each
track piece.
Check the power plug is properly inserted into the powerbase.
Check hand controllers are powered and bound correctly to each lane
For beginners reduce the max power in the ARC app to prevent excess speed.
x2
x2
x2
x2
x2
x1
x1
x1
x8
x3
x1
x8
x2
x4
x1
x2
x4