Hortitek Raider Series User manual

RAIDER ELECTRONIC
COOL BALLAST
INSTRUCTION MANUAL

INSTALLATION AND SET UP
Hortitek Raider Electronic cool Ballasts are designed for ease of use.
Installation is complete in only 5 steps:
1. Mount the ballast in a dry, well-ventilated area that is free from dust and dirt.
2. The built-in mounting holes can be used to securely mount the ballast to a
wall.
3. Connect the ballast to the lamp using the output lead.
4. Connect the ballast to a suitable power source and set the dimming level.
5. Start gardening!
Hortitek Raider Electronic cool Ballasts are the solution of choice
for expert gardeners. The needs of all gardens are met with
variants of 400W, 600W and 1000W; with dimmable light output,
also feauturing a bearing fan to ensure cool operation.
IMPORTANT NOTES
•Only use this ballast with lamps of the same type and power rating as
printed on the ballast housing.
•Only connect this ballast to the power source for which it was designed. This
information is printed on the ballast housing.
•The recommended length of the cable from the ballast to the lamp socket
should not exceed 15m.

SAFETY PRECAUTIONS
SPECIFICATIONS
•Do not power on the ballast without having securely connected a light
assembly (including a lamp) to the lamp supply lead.
•When powering on the ballast, ensure that the lamp is igniting successfully.
If it fails to ignite, turn the power off immediately and inspect the lamp for
signs of faults. If the lamp is without defects, disconnect the ballast from the
power immediately as it may be faulty.
•The ballast should be operated in a dry, well-ventilated, dust-free area.
•Suitable for indoor use only.
•Do not carry the ballast by the power leads.
•Ensure all power lead connections are secure and that all cables are
positioned safely.
•After turning off, always allow time for the lamp to cool prior to re-ignition.
•This product may cause interference to radio equipment and should not be
operated near maritime safety communications equipment or other critical
navigation or communication equipment which operate between 0.45-30
MHz. In the event of interference, relocate or cease operation of the ballast.
•Do not attempt to open, rewire or reconfigure this ballast. This will void the
warranty and may cause serious injury or death.
MODEL
10A 2M 0.2M220 - 250V 95% <10%50/60Hz100 - 268V
1000W
INPUT VOLTAGE INPUT FREQUENCY MAX CURRENT
120-2[email protected]
OUTPUT VOLTAGE EFFICIENCY THDV FUSE INPUT CABLE OUPUT CABLE
8A 2M 0.2M100 - 120V 94% <10%50/60Hz100 - 268V
600 120-2[email protected]
8A 2M 0.2M110 - 130V 95% <10%50/60Hz100 - 268V
400 120-2[email protected]2.6A

hortitek.com.au