Hoselink L451 User manual

Solar LED PVC Rope Light | Warm
White | 30m | FLEX User Manual
MODEL: L451
MODEL: L451
For more information visit
hoselink.com.au
or call
1300 900 617
Cultivating Connections
youtube.com/hoselink
Cultivating Connections
Solar LED PVC Rope Light | Warm
White | 30m | FLEX
User ManualUser Manual
Using the Remote
AOn
BOff
CReset
DLighting Mode
EDecrease Brightness
FIncrease Brightness
GTiming Options
The remote comes with a 3-volt CR2025 button battery
included. To replace the remote’s battery, undo the screw
on the back of the remote. Then, hold in the side clip on
the battery compartment and pull to remove it. Swap the
batteries, then return the compartment to the remote and
tighten the screw back into place. Dispose of used batteries
correctly and safely.
DO NOT USE THIS LIGHT UNDERWATER OR IN LOW-LYING PUDDLES.
A B C
D
E
G
F
WARNING:
KEEP BUTTON BATTERIES OUT OF REACH OF CHILDREN.
• These batteries can cause severe or
fatal injuries in 2 hours or less, due
to chemical burns and potential
perforation of the esophagus, if it is
swallowed or placed inside any part
of the body.
•Never allow children to replace the
button batteries in any device.
•If it is suspected a button/coin battery
has been swallowed or otherwise placed
inside any part of the body, a person
should contact the Australian Poisons
Information Centre on 1311 26 immediately
for 24/7 fast, expert advice.
•Regularly examine devices and
make sure the battery compartment
is correctly secured, e.g. that the
screw or other mechanical fastener
is tightened. Do not use if
compartment is not secure.
•Dispose of used button batteries
immediately and safely out of reach
of children. A battery can still be
dangerous even when it can no
longer power the device.
•Tell others about the risk associated
with button batteries and how to
keep their children safe.

Kit Contents
1 x 30m LED PVC Rope Light 1 x Solar Panel
1 x Extension pole, nut and screw 1 x Ground Spike
1 x Hardware Kit : 1 x Screw & 1 x Masonry plug
Lighting Modes
The Solar LED PVC Rope Light has 8 lighting modes:
1Cycle through all modes 2 Twinkle
3 Pulsating Light 4 Fading Pulse
5 Quick Pulse 6 Slow Flash
7 Quick Flash 8 Constant Light
Activate the light
Use the ‘Power’ button located on the back of the solar
light to turn the lights on. To test the light, hold your hand
over the solar panel and check if the light comes on.
Once the light has been activated you can use the remote
to control the light. Press the ‘MODE’ button or one of the
numbers between 1-8 on the remote to select the desired
light setting. The solar panel has a built-in intelligent light
sensor, which detects darkness, automatically illuminating
the light at dusk and turning it off at dawn.
NOTE. You can control light settings with the remote but
only once the power button has been activated (ie. The
remote will not turn the power on/off).
Product Installation
STEP 1 Find a suitable location
While the PVC LED Rope Light may be placed out of
direct sunlight, the solar panel will need access to direct
sunlight to charge. For optimum results, charge for 6-8
hours per day. Ensure the 2m cable will reach between the
solar panel and rope light.
STEP 2 Install Solar Light
Product Installation – Option A
Ground Spike
A.1 Push the ground spike into the extension pole and
attach it to the back of the solar panel. You can angle
the direction of the solar panel by using the black screw
found on the extension pole.
Product Installation – Option B
Using supplied hardware
B.1 Mark out hole with a marker pen.
B.2 Drill the hole using a 6mm drill piece for masonry
installation. Gently hammer the plug into place and then
secure the screw tightly.
B.3 For timber, drill 3mm pilot hole to guide screw into
place ( plastic plugs are not required ).
B.4 Be sure to leave the screw slightly out as this will hang
like a picture.
Product Installation – Option C
Clip built into panel
C.1 Open the clip on the panel and clip it onto thin
surfaces.
Rope Light Installation – Option A
A.1 Wrap the PVC Rope Light around the desired location.
A.2 Connect solar panel to rope light.