Hoshizaki KML-250MAH Service manual

CONTROL SWITCH
SERVICE SWITCH
Front of Icemaker
(KML-351MAH shown)
Side
Top
Cleaning Prep:
Remove the Front Panel, move the control switch to
OFF. After 3 min., move the control switch to ICE, then
replace the Front Panel .
After 3 min., remove the Front Panel, move the
control switch to OFF. This removes the cubes from
the evaporator.
Remove all ice from the dispenser unit/ice storage bin.
ATTENTION! IF ON DISPENSER, turn off the dispenser
power supply after dispensing all the ice.
Cleaning:
Remove the Front Panel, move the service switch to
DRAIN. Move control switch to SERVICE. Replace
the Front Panel.
After 2 minutes, remove the Front Panel,move the
control switch to OFF.
Dilute Hoshizaki Scale Away with warm water (see Table below).
Remove the Front Insulation Panel and pour cleaning solution
into the water tank. Replace the Front Insulation Panel.
Left Side
View
Ice Machine
KML-250MAH, MWH
KML-351MAH, MWH
KML-451MAH, MWH
KML-631MAH, MWH, MRH
Sanitizing:
Dilute 5.25% chlorine
bleach* with warm water
(see Table below)
KML-451 and smaller
Bleach
1 fl. oz (30 ml)
Warm Water
2 gal. (7.6 l)
KML-631
Bleach
1.25 fl. oz (37 ml)
Warm Water
2.5 gal. (9.5 l)
* Use bleach without additives.
Remove the front insulation
panel
Pour the sanitizing solution
into the water tank
Replace the front insulation
panel
Move service switch to
WASH and control switch to
SERVICE, replace the front
panel
After 15 minutes, remove
front panel
Move service switch to DRAIN,
replace the front panel
After 2 minutes, remove
front panel
Move control switch to OFF
3
min.
3
min.
Cleaning & Sanitizing
AMMONIA
Cleaners
The icemaker must be cleaned & sanitized at least once a year.
ATTENTION!
Do not leave icemaker
unattended when panels are off
continued on the back…
Tech Support: 1.800.233.1940
1
2
3
4
14
15
16
17
5
6
#51007 | 8.22.2016
Page 1
After 2 min.