Warning and caution symbols
These symbols are used throughout the instruction manual to alert the user to potential
safety hazards as follows :
Warning …Notice when incorrect handling could cause the user's death or serious
injury.
Caution …Notice when incorrect handling could cause injury to the user or material
damage.
Even if the instructions do not have Caution mark, there are some possibilities for a
serious situation. Follow the instructions.
２
Precautions
1. The blower becomes hot when the power is on and remain hot right after turning the
power off. Do not touch the blower with your hand, face or do not allow flammable
material such as paper,wood or plastics to contact.
2. Keep highly-volatile chemicals such as alcohol, thinners and paints away from the
blower during heating and right after turning the power off, since the blower has been
hot.
3. The power cord has a grounded plug. When use converting into ungrounded plug, be
sure to ground. If being without properly grounded, electric shocks could result.
4. Disconnect the HS-559 power cord from the outlet and check that the blower, hood
and heater have cooled down to ambient temperature, before starting to replace the
heater. If the adjacent parts are still hot, or if the power cord is still connected, do not
start to replace the heater, otherwise electric shocks or burns could result.
5. Use only specified power. If the HS-559 is connected to any other power supply, this
could cause overheating and a damage.
6. Hot air (600℃ maximum) blows out of the nozzle. Do not put the hands, the face or
any part of the body within 30cm of the direction of the hot air blow. This could
causes a burn and injury.
7. Metal pipes of the nozzle and its adjacent part obtain high temperature. Do not
contact any flammable material or the body. There is a possibility of a burn or a fire.
8. Do not wave about the blower. If it touches the body, it could cause a burn. And this
Could cause a short circuit or a damage of the cord inside the airhose.
9. Be sure to put off the power switch and the heater switch after the operation or
suspend the operation.
10.The airhose connected to the blower should not be contacted with the heat part.
Warning
1. Prior to using, surely remove the cable tie on the back panel. If powered without
removing the cable tie, this could cause a malfunction. (Refer to page4)
2. Secure the inner pump with a cable tie when transport the unit to its former state.
(Refer to page8)
Caution
