HUBBELL LIGHTING COMPASS CELR User manual

WARNING – This product contains chemicals known to the State of California to cause cancer, birth
defects and/or other reproductive harm. Thoroughly wash hands after installing, handling, cleaning,
or otherwise touching this product.
Recessed Mount LED Emergency Exit
CELR
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should
always be followed including the following.
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. Do not use outdoors.
2. Do not let power supply cords touch hot surfaces.
3. Do not mount near gas or electric heaters.
4. Equipment should be mounted in locations and at heights where it will not readily be
subject
to tampering by unauthorized personnel.
5. The use of accessory equipment not authorized by the manufacturer may cause an
unsafe condition.
6. Do not use this equipment for other than its intended purpose.
7. Servicing of this equipment should be performed by qualified service personnel.
8. Test cycling: the Life Safety Code (NFPA 101) requires testing of emergency lighting units
once a month for a
minimum of 30 seconds, and once a year for a minimum of 90 minutes.
INSTALLER:
•SEE UNIT LABEL FOR ADDITIONAL MODEL SPECIFICATIONS
•SAVE THESE INSTRUCTIONS FOR USE BY OWNER/OCCUPANT
RECYCLING INFORMATION
All steel, aluminum and thermoplastic parts are recy-
clable.
NOTICE: Emergency units contain rechargeable batter-
ies which must be recycled or disposed of properly.
Hubbell Lighting, Inc. Life Safety Products • www.dual-lite.com
Copyright©Hubbell Lighting, Inc., All Rights Reserved • Specifications subject to change without notice. • Printed in U.S.A.
COMP0003_INST_SHT 5/20
PACKAGE CONTENTS
Part Description Quantity
1 LED Edge-Lit EXIT Sign 1
2 Adjust Bracket and Bar hanger 2
3 Hardware Bag 1
ELECTRICAL CONNECTIONS
1. Make the proper supply wire connections.
2. If using 120 VAC, connect the black and white wires to the
building utility.
3. If using 277 VAC, connect the orange and white wires to the
building utility.
4. Cap o unused wire. In all cases, use standard wire nuts in
connection to wires.
WIRING DIAGRAM

INSTALLATION INSTALLATION
1. Refer to assembly drawing before you
start installation.
2. Position recessed kits and bar
hangers between joists. Make
sure bar hangers are extended
be hanged in the correct position.
Position recessed kits temporarily by
hammering nail tabs on bar hangers,
then secure permanently with screws.
Bar hangers should be level with
bottom of joists.
3. Adjust height of recessed kits
vertically using adjusting slots
and then tightening all screws on
adjusting slots and bars hanger
bracket to back-box screws
5. Connect battery connector.
6. Connect test switch and LED Indicator
cables
via connectors.
7. Secure trim plate by using provided
screws.
4. Make proper electrical connections at
J-Box in the metal box or at junction
box in the ceiling of building. If using
120VAC, connect black and white
leads to the building utility. If using
277VAC, connect orange and white
leads to the building utility. Cap
o unused wire. In all cases, use
standard wire nuts in connection
to leads. You may use holding wire
during wiring.
NOTE: FIRST TURN OF ELECTRICITY
RECESSED CEILING MOUNTING
RECESSED WALL MOUNTING
1. Reference 1-10 step in recessed
ceiling mounting above for recessed
wall mounting.
2. Recessed ceiling mounting rotate 90°
become recessed wall mounting.
DETERMINE DIRECTIONS
1. If indicator chevron is required,
maintain chevron and remove locator
template.
2. If indicator chevron is not required,
remove both the chevron and locator
template.
ASSEMBLY DRAWING