8
S/N
1
2
(1)
(2)
3
4
5
6
7
8
9
10
Key/Switch Function
Throttle/Rudder stick
Push the stick forward or backward and the quadcopter will ascend or descend
(respectively). Push the stick left or right and the quadcopter will rotate
counterclockwise or clockwise (respectively).
Push the stick forward or backward and the quadcopter y forwards or backwards
(respectively). Push the stick left or right and the quadcopter will y left or right
(respectively).
Push the stick forward or backward and the quadcopter y forwards or backwards
(respectively). Push the stick left or right and the quadcopter will rotate
counterclockwise or clockwise (respectively).
Push the stick forward or backward and the quadcopter bwill ascend or descend
(respectively). Push the stick left or right and the quadcopter will y left or right
(respectively).
Elevator/Aileron stick
Elevator/Rudder Stick
Throttle /Aileron stick
Power key Long press for 1.5 seconds and the transmitter will power on. To power off,
long press for 1.5 seconds while the transmitter is on.
Return to Home Long press for 1.5 seconds and the quadcopter will perform a Return to
Home. To terminate Return to Home, short press for 0.5 seconds.
Auto Takeoff/Auto Land Long press for 1.5 seconds and the quadcopter will perform an Auto Takeoff or
Auto Land (if the unit is airborne).
Transmitter status LED When the transmitter is powered on, the LED should be solidly lit. If the
transmitter is low on power, the LED will ash rapidly.
Bluetooth status LED If the transmitter and quadcopter fail to pair or they are simply disconnected
because the quadcopter is powered off, the LED will slowly ash blue. If the
transmitter and quadcopter are successfully connected, the LED will turn solid blue.
Photo key Short press the key to take a photo.
Video key Short press once to start the recording; short press again during the
recording to stop the recording.
Camera head adjustment
key Temporarily no function.
2-2 Battery installation
If applicable, remove the
compartment screw. Slide open
the compartment hatch.
● Do not mix new and old batteries
● Do not cross-use different types of batteries at the same time
Insert 4 AAA batteries into the battery
compartment. Take note to make sure you
have correctly matched the polarities.
Slide the compartment hatch
to close it; if applicable screw it
shut.
PULL PUSH
