Before using the light for the first time you need to charge it for 8 hours. After that the
battery should last charged for around 2 - 3 hours.
Charge indicator light
Colorful small night lamp switch
USB
power port
Plug other end of USB power cable into USB
power source port. You can also charge by
power adapter (optional).
You can use the lamp while charging.
The battery will be fully charged after
approximately 4-5 hours.
Power cable
Red light ON when battery is charging
Red light OFF when charging complete
Pressing the switch repeatedly cycles between the
night lamp modes:
Level 1: Colorful small night lamp automatic cycle
Level 2: Dim red light
Level 3: Off
See ”Operating Instructions“ for setting
the date / time / calendar.
The battery cell may move during transport of the lamp, and may
lose contact. To eliminate play inside the battery holder, there is a
small thin piece of foam between the battery and the cover to remo-
ve any excess free play.
Turn the battery cover CCW and remove it. Remove the battery cell
from inside the lamp case. Note the cell direction.
The lamp is delivered with a sealed cell battery. Open the cover, re-
move the seal from the battery, and re-install the battery in the lamp.
In order to use the lamp properly, please change the battery cell
when the LCD screen does not display information anymore.
Install a new 3V battery cell in the same direction as the original
cell. Reinstall the battery cover and turn it CW until it locks in
place.
c
l
o
s
e
Press the power switch repeatedly to turn on/off
the lamp, and adjust the brightness (3 levels).
• To avoid damaging the lamp, do not over-extend the joints.
• To avoid electric shock, do not disassemble the lamp yourself.
• Do not use the lamp in or near rain or damp conditions.
• Keep the lamp away from flammable and/or humid surroundings.
• If there is a problem with the lamp, it should be checked and repaired by a professional
lamp repair person.
TIME
CALENDAR
DAY
TEMPERATURE
!
Input power: USB 5V/500mA
Lithium battery: 3.7V/600mAh
Battery cell for LCD: CR2032/3V
51mm
2“
90mm
3.54“
50mm
1.96“
1.96“
50mm
62mm
2.44“
91mm
3.6“
33.5mm
1.3“
Base can be removed from lamp body
o
p
e
n
243mm 9.5“
250mm
9.8“
important - first time charging LcD DispLaY screen Dimensions
specifications
power switch
coLorfuL night Lamp switch
instaLLing the batterY ceLL
charge methoD
