Human Touch Perfect Chair PC600 User manual

REMOVING THE CONTROL MODULE
1. Unplug the chair.
2. Tip the chair forward, resting the headrest on the floor.
3. Using a Phillips-head screwdriver, remove the screw that secures the control module to the chair (Fig.1).
4. Slide the control module to the right, then pull it toward you to remove it from the chair (Fig.2).
5. Remove the cable clamp from the control module (Fig.3).
6. Note which cable is plugged into which receptacle (or mark them), then unplug the three cables from the
control module. (Fig.4).
Tools Required: Phillips-head screwdriver
NOTE: SAVE ALL REMOVED PARTS FOR USE DURING REASSEMBLY
REPLACING THE MAIN CONTROL MODULE
It is imperative that Human Touch®products are repaired in a manner that ensures product safety and regulatory compliance and that is fully consistent with the practices used
during the manufacturing process. Therefore, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these repair
instructions. Failure to adhere to these instructions voids the product warranty and releases Human Touch from all liability for injury or product damage resulting from the repair.
SERVICE LEVEL: 2
1
(Fig.1)
(Fig.2) (Fig.3) (Fig.4)
February 11, 2016
PC-600/610
Control module
Control module
Cable guide

2
INSTALLING THE NEW CONTROL MODULE
Please send any questions or comments regarding these instructions to: [email protected]
© 2016 Human Touch®, LLC.
1. Plug the three cables into the same control module receptacles as they were plugged into originally, making sure the plugs are in as far as they will go (Fig.5).
2. Replace the cable clamp to secure the cables in position.
3. Align the control module mounting guide on the side containing the label with the top of the mounting block, then push downward to engage the lower edge
of the block.
4. Slide the control module to the left until the gap in the mounting guide is lined up with the screw hole in the stretcher bar (Fig.6).
5. Replace the screw to secure the control module to the stretcher bar.
6. Plug in the chair, then verify that all functions are working properly. If the recline controller functions are reversed (up/down controls the backrest recline and
forward/backward controls the footrest movement), the two cables located on the same side of the control module were plugged into the wrong receptacles.
Unplug the chair, reverse the two cables, then plug in the chair and verify it is functioning properly.
(Fig.5)
(Fig.6)
Plugs are in as far as
they will go
Control module
Stretcher bar
Gap