HUSSMANN CORPORATION • CHINO, CA 91710
9
Hot or Cold Food Counters
ISLA Food Counters IM-FS IM-FH IM-FR 10/20
UNLOADING CASES FROM TRAILER
To protect the case and its base from damage and
make positioning the case easier, each merchandiser
can be shipped dierently, depending on the original
order request. Your case(s) could be on a skid, rails,
crated and skidded, or just blanket wrapped.
Improper handling may cause damage to the
merchandiser when unloading. To avoid damage:
1. Do not drag the merchandiser out of the trailer.
Use a Johnson bar (mule, aka J-bar), a dolly or a
forklift.
2. Use one or two dollies depending on length of the
case to remove the merchandiser from the trailer.
3. Useonetotwodolliestorelocatethemerchandisers
to the lineup.
NOTE:
When lifting case, be sure to lift case from
a point on case body. Improper lifting may
damage factory-installed end panels.
See Following Diagrammed Pages
REMOVING SHIPPING SKID AND/OR CRATE
DO NOT TILT or LAY MERCHANDISER
ON ITS SIDE.
1. Check oor where cases are to be set to see if it
is a level area. Determine the highest part of the
oor.
2. If the case is crated, unscrew/remove nails from
one (1) of the walls of the crate, leaving three (3)
sides and the top of the crate.
3. Then unscrew/remove the nails from around the
base of the crate (frame), releasing it from the skid.
4. CAREFULLY remove/slide away the remaining 3
walls and top of the crate. (Body panels should
be on the case, but if they are not, carefully
remove and set aside in safe place so as not to be
damaged/scratched)
5. Remove any braces/L-brackets attaching the
merchandiser to the skid.
6. Remove the merchandiser from skid, by lifting only
at base of case, using the case’s rails!
7. Once the case is removed from the skid, the
merchandiser must be lifted —NOT PUSHED— to
reposition.
RECYCLE SHIPPING
BRACES AND
PACKAGING
HUSSMANN AND HATCO SERIAL PLATE
LOCATIONS
DOCUMENT ALL SERIAL NUMBERS
PRIOR TO HEATING!
Depending what type of case ordered (with or without
rear doors on the back of the case), the Hussmann
serial plate is either located:
1. (No rear on back) the top FRONT left-hand
interior rear wall
2. (With rear loading doors) in the lower left corner
on the BACK of the case.
Make note of the case’s serial number in the area
provided at the end of this guide.
HATCO serial numbers for each of the surface
warmers are located under each warmer. Document
the serial numbers in the space provided at the end
of this guide.
EXTERIOR INFORMATION
Do NOT walk on top of or inside of merchandisers
ordamageto the merchandisers and serious
personal injury could occur. They are not
structurally designed to support excessive external
loading such as the weight of a person.
Do not place ammable materials or objects on top of the
merchandiser.
3. Installation
