HYCHIKA BB729 User manual

Instruction Manual
Paint Sprayer
-Better Tools for Better Life-
BB729

- 02 -
-Better Tools for Better Life-
If any problems, please contact our after-sales email: [email protected]
Model:BB729
2.
3.
Suitable for painting furniture, fences, doors, windows, walls, ceiling, and for car repairing, high
altitude operation and, and so on.
4.
Before use the electric spray gun,
material preparation is the first stage.
Please refer to the thinning chart and picture.
Technical parameters：
Function
How to use
Material
Oil enamel
Oil based primer
Oil stain
Clear sealer
Polyurethane
Lacquer
Varnish
Automotive finishes
Latex
Viscosity(DIN-S)
25-60s
30-60s
No thinning required
No thinning required
No thinning required
25-30s
25-30s
20-40s
45-90s
DIN-S: The time for the liquid to run out of a funnel.
Rated power: 4.6A
Rated voltage:120V
Frequency: 60Hz
Rated speed: 32000RPM
Wire length:3m
Spray distance: 8-10 inch
Width: 8-12 inch
Max viscosity: 80DIN-s
Tank capacity:800ml

- 03 -
-Better Tools for Better Life-
If any problems, please contact our after-sales email: [email protected]
1)
2)
a)
Unscrew the paint container from the spray gun.
Adjust the suction tube
If spraying upward, the inclined end of the straw should point to the back of the gun.

b)
3)
4)
a)
b)
c)
- 04 -
-Better Tools for Better Life-
If any problems, please contact our after-sales email: [email protected]
If spraying downward, the inclined end of the straw should point to the front of the gun.
Pour material into container, make sure not to exceed 800ml.
Remove the motor
Hold the spray gun with your hand.
At the same time, hold the motor handle by hand and rotate it 90 ° counterclockwise.
Pull out to remove the motor from the spray gun.
200
300
400
500
600
700
800

- 05 -
-Better Tools for Better Life-
If any problems, please contact our after-sales email: [email protected]
5)
a)
b)
c)
6)
a)
b)
7)
Connect the spray gun body to the motor
Hold the spray gun by hand, align the slot on the spray gun with the slot on the motor, and then insert it (as shown in the
figure).
Hold the motor handle by hand and rotate the right hand 90 ° clockwise.
When the gun is parallel to the main engine, it is locked.
Adjust the needle adjusting screw to meet your requirement.
Adjust the screw to left to decrease paint volume, lower paint thickness
Adjust the screw to right to increase paint volume, increase paint thickness
Turn on the power switch and press the trigger to spray paint.

- 06 -
-Better Tools for Better Life-
If any problems, please contact our after-sales email: [email protected]
5.
EVEN COAT THROUGHOUT
Correct:
Keep stroke smooth and at even speed.
Incorrect:
Do not flex wrist while spraying.
How To Spray Properly: