hylite Mightylite MFL015 Manual

Mightylite 15W / 24W LED Floodlights
Model: MFL015 / MLF024
Installation & operating instructions
F4 Enterprises Limited
7 Abbey Square, Chester
CH1 2HU, UK
Tel: [phone]
www.f4enterprises.co.uk
Fig.7
Fig.6
Fixing Holes
FIXING THE CONNECTION BOX (Cont)
• UsetheconnectionboxFixingHoles[Fig.6]tomarkthe4drillholesrequiredto
 securetheboxtothewall(andmarkthecableoutletlocationifrequired).Drill
 thewallandscrewtheconnectionboxontothewallusingthescrewsandwall
 plugsprovided.
• Oncethewire(s)hasbeenfedthroughtheSealingGland,thenutonthegland
 shouldbegentlytightenedupagainsttheglandbody[Fig.8]toensurethe
 wire(s)issecuredinplaceandnowatercangetthoughintotheconnectionbox.
WIRING THE FLOODLIGHT
• Oncethepowercablehasbeenfedthroughthecablegland(orsealing
 grommetifusingtheknock-outattherearoftheconnectionbox) 
 approximately6mmofinsulationshouldbestrippedfromeachofthecoresof
 ACcablereadytoattachittotheterminalblockinthefrontofthelighttting.
NOTE: The Hylite Mightylite is a Class 2 fitting, therefore no Earth is required
CONNECTING TO POWER SUPPLY
• ConnecttheBROWNorRED(Live)wiretotheterminal(marked“L”)holdingthe
 singleBROWNwireintheoodlightunit[Fig.8].
• ConnecttheBLUEorBLACK(Neutral)wiretotheterminal(marked“N”)holding
 theBLUEwireintheoodlightunit.
• Aftertheconnectionshavebeensecured,theoodlightfront(ConnectionBox
 front)shouldbefastenedtotheConnectionBoxusingthe4ConnectionBox
 Screwsprovided[Fig.9]
• Oncescrewsaresecure,thescrewcovers(provided)shouldbettedshouldbe
 tted[Fig.9]
• ToadjusttheMightyLitesimplyholdtheConnectionBoxrmlywhilstmoving
 theheadoftheoodlighttotherequiredposition.
Fig.9
Fig.8

WIRING REQUIREMENTS
Fig.1
FUSE
3 AMP FUSE
TO LAMP
FROM MAINS
SUPPLY
DOUBLE-POLE SWITCHED FUSED SPUR
F
1
2
5
4
3
T R
PIR
sensor
More sensitiveLess sensitive
L
N
SL
E
Override switch
Live
C L1
Neutral Earth
To Mains MightyLite
N In N Out
L In L Out
Theunitrequiresconnectiontoa230AC50Hzmainselectricitysupply.
Itisrecommendedthattheunitisconnectedtothedomesticlightingcircuitviaa
5ampfusedspurandusing2-coreroundexiblecableofatleast1mm2gauge
(waterproofcableshouldbeusedforoutdoorinstallations).
Itisalsoadvisabletoinstallasinglepolewallswitchtoalloweasycontrolofthe
oodlight(Fig.1).
IMPORTANT OPERATION & MAINTENANCE INSTRUCTIONS
TheHyliteMightyliteoodlightalowenergy,highpoweredoutdoorLEDoodlightwhichissuitableforinstallationonsolid
wallsinarangeoflocationsincludingentrances,gardens,staircases,garagesandoutdoorparkingareas.
Theunitrequiresconnectiontoa230AC50Hzmainselectricitysupply.
IMPORTANT SAFETY INSTRUCTIONS
HYLITE MIGHTYLITE – INSTALLATION AND OPERATING INSTRUCTIONS
  DONOTpositionthelightnearammableorcombustiblematerials(suchasclothorpaper)ornearammable, 
  combustibleorexplosiveliquids,solids,gasesorequipment.
  DONOTlookdirectlyintothelightorpointittowardsaperson’seyes.Thislighthasaveryintensivelightoutputwhich,
  ifincorrectlyused,couldcauseeyedamage.
  ALWAYSdisconnectthemainspowersupplybeforeinstalling,servicingorperforminganymaintenance.
  ALWAYSmaintainthelightingoodcondition,withrepairsonlyundertakenbyaqualiedelectrician.
  ONLYcarryoutrepairsusinggenuineparts.Non-authorisedpartsmaybedangerousandwillinvalidatethewarranty
WARNING: THIS PRODUCT MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN, AND CHECKED TO ENSURE IT IS SAFE BEFORE USING
PLEASEFOLLOWTHESEINSTRUCTIONSCAREFULLYBEFOREATTEMPTINGTOINSTALLANDOPERATETHISLIGHT
  Theriskofelectricshockshouldbeminimizedbytheinstallationofappropriatesafetydevicesincludingthe 
  incorporationofanRCCB(ResidualCurrentCircuitBreaker)intothemaindistributionboard.
  DONOTwirethisoodlightdirectlyintothelightingcircuit.Useaswitchedfusedspur.Cablesshouldalwaysbe 
  protectedagainstshortcircuitandoverloadbyuseofanRCD.
  Ensurethevoltagemarkedontheproductisthesameastheelectricalpowersupplytobeused.
  DONOTinstallthelightwhereitislikelytobeknockedorhit;inhotorhumidconditionssuchasbathrooms,shower
  roomsorsaunas;ornearanexhaustoutlete.g.boilerue,dryeroutlet.
TOOLS REQUIRED
Electric/hand-helddrill
No.8masonrydrillbit
Electriciansscrewdriver
Largecross-headscrewdriver
Smallcross-headscrewdriver
Wire cutters
THISPRODUCTISSUITABLEFORWALLMOUNTINGONLY.
PARTS INCLUDED
1 x Mightylite LED Floodlight
1xConnectionbox
1xCablegland
4xConnectionboxscrews
4xConnectionboxscrewcovers
4xConnectionboxxingscrews
4xConnectionboxxingscrewcovers
Fig.2
FUSE
3 AMP FUSE
TO LAMP
FROM MAINS
SUPPLY
DOUBLE-POLE SWITCHED FUSED SPUR
F
1
2
5
4
3
T R
PIR
sensor
More sensitiveLess sensitive
L
N
SL
E
Override switch
Live
C L1
Neutral Earth
To Mains MightyLite
N In N Out
L In L Out
3-5m
Fig.5
Fig.4
Fig.3
Landscape
Portrait
FIXING THE CONNECTION BOX
WARNING: Isolate the power supply before installation.
• Positiontheunitonthewallandmarkthepositionfortheconnectionbox
 (whichcanbepositionedineitherlandscapeorportraitplanes[Fig.3]).
• Ensurethewirescaneasilyentertheconnectionboxthrougheitheroneofthe
 knock-outsonthesideoftheconnectionbox,orthroughtheknock-outatthe
 rearofthebox.
NOTE: It is recommended that the knock-outs on the sides of the
connection box are used in conjunction with the cable gland [Fig 4.] as
using the knock-out at the rear of the connection box will reduce the
weatherproof rating of the unit to IP23.
• However,Iffeedingawire(s)throughtheknock-outattherearoftheconnection
 box,thiswillneedtoberemoved,thesealinggrommettted[Fig.5]andthe
 wirepushedthroughintotheconnectionboxBEFOREitissecuredtothewall.
• Iffeedingawire(s)throughthesideknock-outs,itiseasiesttotthecable
 glandtotheconnectionbox[Fig.4]BEFOREsecuringittothewall,andwires
 shouldentertheconnectionboxfromthesidesorunderneath,NOTfromthetop.
CHOOSING A MOUNTING LOCATION
INSTALLATION INSTRUCTIONS
• Mounttheoodlightontosolidbrickorwoodwork,3-5mabovetheground
 [Fig.2]
• Avoidpositioningthelightnearheatsourcessuchashotventilatorducts,air
 conditioningunits,streetlightingortrafcwhichmayinterferewithitsoperation.