Installing Battery to RC Eagle:
1) Unscrew the Bolt on the bottom of the RC
Eagle.
2) Slide the Battery in the battery slot and
connect it to the RC Eagle.
3) Tighten the bolt until the battery cannot slide
out.
To Start Playing:
1) Turn on the remote controller and RC Eagle.
2) Push Joy stick UP and DOWN to pair.
3) Press Start button or gently move RC Eagle
UP and DOWN by hand until wings start
flapping.
4) Gently throw RC Eagle forward to begin Fly.
To End Playing:
1) Put RC Eagle up side down until wings stop
flapping.
2) Turn off the remote controller and RC Eagle.
RC Eagle has altitude sensor, so it flies in the
same altitude all the time.
CONTENTS
BATTERY INSTALLATION
FUNCTIONS
RC Eagle Remote Controller
Remote Controller
Back of Remote Controller
Battery Slot
Green
Indicator
light
Bolt
1
2
3
Side of RC Eagle
Instruction Manual
3.7V 100mAh
Rechargeable Batteries x 2
USB Charger ON / OFF
Hold: ON / OFF
1) Unscrew on the battery cover by screwdriver and
remove the battery cover.
2) Put 2 1.5V AAA batteries in the battery slots with
correct polarity.
3) Slide the battery cover back to the remote controller
and tighten the screw.
Remote controller and RC Eagle will turn OFF automatically when it idle over 12 minutes.
Charging Battery: 20 mins
1) Connect Battery to the USB charger.
2) Connect USB charger to power source.
Joy stick
UP: Speed Up
Down: Slow Down
Start
Elliptical flight
Red Indicators light
Flying Left Circle Flying Right Circle
Figure 8 Flying
Green Indicators light:
Flashing: Remote Controller Pairing.
Light On: Remote Controller Paired.
Infrared obstacle
avoidance device
Flashing: Pairing.
Light On: Paired.
ON / OFF
Hold: ON / OFF
- 1.5V AAA LR03 +
+ 1.5V AAA LR03 -
