HYPER TOY COMPANY RC DINO User manual

MADE IN CHINA
FULL FUNCTION
RC DINO
LITHUM BATTERY
USB CHARGER
This device complies with Industry Canada licence-exempt RSS 210 standard. Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.

CONTENTS
BATTERY INSTALLATION
FUNCTIONS
RC Dinosaur Remote Controller
Back of Remote Controller
USB charging port
ON / OFF
Charging Indicator light
Tail Button
Bottom of RC Dinosaur
Instruction Manual
3.7V 600 mAh
Rechargeable Battery
USB Charging Cable
ON/OFF
Press Once: ON
Hold: OFF
BACKWARD TURN RIGHT
TURN LEFT
FORWARD
INDICATOR LIGHT
Demonstration
1) Slide the open button to right side
and slide the battery cover down to
open.
2) Put 2 1.5V AA batteries in the
battery slots with correct polarity.
3) Close the battery cover.
Button
Press Once: Demonstration Mode
RC Dinosaur walks around and shows what it can do; Mouth light
effect and sound effects.
Hold for 3 seconds: Sleep Mode
Press once again to wake up RC Dinosaur, and turn on remote
controller to controll the RC Dinosaur.
The rechargeable battery is already connect-
ed inside RC Dinosaur.
Remote controller and RC Dinosaur will turn OFF automatically when it idle over 5 minutes.
Charging RC Dinosaur: 60 minutes
1) Connect USB power input to RC
Dinosaur.
2) Connect USB power output from
USB plug / Computer USB.
Red: Charging
Green: Charged
Tail Button:
To detach the tail.
3.7V 600 mAh
Rechargeable Battery