Hyundai power products HTDE511RP User manual

ELECTRIC LAWN MOWER
HTDE511RP
WARNING: Read thoroughly the instruction manual before use.

02

03

SAFETY INSTRUCTIONS
IMPORTANT
READ CAREFULLY BEFORE USE
KEEP FOR FUTURE REFERENCE
Safe operating practices for electrically
powered lawnmowers
Training
a) Read the instructions carefully. Be familiar
with the controls and the correct use of the
machine.
b) Never allow children or people unfamiliar with
these instructions to use the machine. Local
regulations can restrict the age of the operator.
c) Never operate the machine while people,
especially children, or pets are nearby.
d) Keep in mind that the operator or user is
responsible for accidents or hazards occurring
to other people or their property.
Preparation
a) While operating the machine always wear
substantial footwear and long trousers. Do not
operate the machine when barefoot or wearing
open sandals. Avoid wearing clothing that is
loose fitting or that has hanging cords or ties.
04

b) Thoroughly inspect the area where the
machine is to be used and remove all objects
which can be thrown by the machine.
c) Before using, always visually inspect to see
that the blade, blade bolt and the blade
assembly are not worn or damaged. Replace
worn or damaged components in sets to
preserve balance. Replace damaged or
unreadable labels.
d) Before use check the supply and extension
cord for signs of damage or aging. If the cord
becomes damaged during use, disconnect the
cord from the supply immediately. DO NOT
TOUCH THE CORD BEFORE
DISCONNECTING THE SUPPLY. Do not use
the machine if the cord is damaged or worn.
Operation
a) Operate the machine only in daylight or in
good artificial light.
b) Avoid operating the machine in wet grass.
c) Always be sure of your footing on slopes.
d) Walk, never run.
e) Mow across the face of slopes, never up and
down.
f) Exercise extreme caution when changing
direction on slopes.
g) Do not mow excessively steep slopes.
h) Use extreme caution when reversing or
pulling the machine towards you.
05

i) Stop the blade(s) if the machine has to be
tilted for transportation when crossing surfaces
other than grass, and when transporting the
machine to and from the area to be used.
j) Never operate the machine with defective
guards or shields, or without safety devices, for
example deflectors and/or grass collector, in
place.
k) Switch on the motor carefully according to
instructions and with feet well away from the
blade(s).
l) Do not tilt the machine when switching on the
motor, except if the machine has to be tilted for
starting. In this case, do not tilt it more than
absolutely necessary and lift only the part,
which is away from the operator.
m) Do not start the machine when standing in
front of the discharge opening.
n) Do not put hands or feet near or under
rotating parts. Keep clear of the discharge
opening at all times.
o) Do not transport the machine while the power
source is running.
p) Stop the machine, and remove plug from the
socket. Make sure that all moving parts have
come to a complete stop:
- whenever you leave the machine,
- before clearing blockages or unclogging
chute,
06

- before checking, cleaning or working on the
machine,
- after striking a foreign object.
Inspect the machine for damage and make
repairs before restarting and operating the
machine;
If the machine starts to vibrate abnormally
(check immediately):
− inspect for damage,
− replace or repair any damaged parts,
− check for and tighten any loose parts.
Maintenance and storage
a) Keep all nuts, bolts and screws tight to be
sure the machine is in safe working condition.
b) Check the grass collector frequently for wear
or deterioration.
d) On machines with multi blade, take care as
rotating one blade can cause other blades to
rotate
e) Be careful during adjustment of the machine
to prevent entrapment of the fingers between
moving blades and fixed parts of the machine.
Recommendation for class II machine
The machine should be supplied via a residual
current device (RCD) with a tripping current of
not more than 30 mA
07

Additional instructions
- Do not use this tool in wet weather.
- Do not use the tool in bad weather conditions
(rain, thunderstorms, storms, etc.).
- The handling / connection of the cables must
be dry.
- Always avoid contact between an electrical
outlet or cable and a wet area (puddle or wet
grass).
- The connections between the cables and the
plugs must be sealed. Use extension cords
only with commercially available waterproof
plugs or standards.
- The power supply cables must not be of a
quality inferior to type H05RN-F.
H05RR-f.H05WF.H05VVH2-F. for outdoor use,
with a minimum section of 1.5 m ².
- Secure the cable to the hook before turning
on the equipment.
- The permanent connection of any electrical
device in a building must be done by a
qualified electrician in accordance with the
electrical standards in force.
- An incorrect connection can cause serious
injury or death.
- Before connecting the appliance, check that
the plugs and extension cords are in good
condition. Do not use the appliance if the
appliance is damaged or worn.
08

- Never use the appliance if the guards are
defective or without safety devices, for
example the grass catcher in place.
- Use only an extension cord attached to a
coupler according to the IEC 60320-2-3
standard.
- Always direct the cable away from the device.
- Mow by day or under adequate artificial light.
- Avoid operating the unit in wet grass or in the
rain.
- Never ride the power cable with the lawn
mower.
- When mowing, the cable should always be
behind the mower and in the area where
grass has already been cut.
- Use the cable hook to prevent unexpected
disconnection of the cable.
- Make sure the plug is inserted correctly and
do not force the plug.
- Never pull the lawn mower by its power cable,
and never pull the cable out of the socket.
- Do not expose the cable to sources of heat.
Do not allow it to come into contact with
solvents, oil, fuels, or smudged objects.
- If a cable is damaged during use, disconnect
the plug immediately. DO NOT TOUCH THE
CABLE BEFORE DISCONNECTING THE
SOCKET.
- Unplug the unit from the power sources:
oWhenever you leave the device
09

oBefore solving a problem.
oBefore checking, cleaning or working on the
unit.
oIf the unit starts to vibrate abnormally
- Always ensure your position on the slopes.
- Mow facing slopes, never up and down.
- Be extremely careful when changing direction
on slopes.
- Do not mow on slopes of more than 20 °.
- Walk, never run, do not get pulled by the lawn
mower.
- Be extremely careful when pulling the lawn
mower toward you.
- Stop the engine if you must tilt the lawnmower
for transport, when crossing areas other than
grass, and when transporting it to another
area to be mowed.
- Never operate the lawn mower with defective
protections, or without a safety device, such
as a deflector or grass catcher that is not in
place.
- Start the engine with the switch on, cautiously
as instructed, and feet well away from the
blade.
- Do not tilt the mower when starting the
engine.
- Start the engine on a flat surface with no
obstacles or grass too high.
- Do not put your hands or feet under rotating
parts.
10