I-View EPoC-151VA User manual

1
Product Overview:
1. Power jack: Plug DC48~56V power adapter. (The EPOC-151VA cannot )
2. Pwr: The LED indicates the power status. On: Power on; Off: No power.
3. Ethernet/PoE: Giga Ethernet RJ45 connector, attaches to Hub, PC or IP Camera via Cat. 5e, 6 or 7 patch
cables.
4. Eth: To indicates the Ethernet communication status. Flash: Communicate with Traffic; Off: No connection.
5. Extend: RJ45 Female (No LED)/BNC Connector allows 10/100/1000 Base-T Ethernet and PoE power to be
transmitted using Cat. 5e (or better) UTP cable with 4 pair wires or RG59 (or better) Coaxial cable.
6. Link: The LED indicates the cable link status. The LED will be on after 10 seconds when first connection is
success; Off: No connection.
7. Terminal Block:Support DC12V power output.
Packing Checklist:
Check the package box the following items are included:
EPoC-151VA x1 pc
EoPC-151PS (or EPoC-151HP ) x1 pc
DC power adapter x 1pc
Installation Steps:
Camsite
1. Connect the Hub or IP camera RJ45 connector to the 10/100/1000 Base-T Ethernet port of EPoC-151PS (or
EPoC-151HP) using a standard Cat 5e (or better) cable of maximum 100 m (328 feet) in length.
2. Connect one end of the long UTP cable (Cat. 5e or better ) the RJ45 (No light) connector or Coaxial cable (RG59
or better) to BNC connector of EPoC-151PS (or EPoC-151HP).
Hubsite
1. Connect the Switch Hub RJ45 connector to the 10/100/1000 Base-T Ethernet port of EPoC-151VA using a
standard Cat.5e/6 cable of maximum 100 m (328 feet) in length.
2. Connect one end of the long UTP cable (Cat. 5e or better ) the RJ45 (No light) connector or Coaxial cable (RG59
or better) to BNC connector of EPoC-151VA .
3. When the EPoC-151PS (EPoC-151HP) cannot receive power through the Wire cable, please change to DC56V
power adapter to EPoC-151VA . Please refer to “Power Distance VS. Cable Impedance” table.
Giga Ethernet/PoE Extender over UTP Cable Installation Guide V1.3
6
5 4 3 2
1 5
6
4
2
3
7
5 5

2
Product Application Diagram
The Ethernet over 2-Wire (Coaxial or UTP) Cable system provides Giga Speed (Upload: 500M/s; Download:
500M/s) Bandwidth and PoE power transmission. It supports virtually any type of Cat. UTP wire or coaxial cable
or any 2-Wire, including such as Cat.5, 5e, 6, or 7, RG58, RG6, RG 7 cable. And different wire types can be
concatenated together, as needed.
To avoid the interference signal, we strong recommend using the Cat. STP cable (or Coaxial cable) for Ethernet/PoE signal
transmission when there are more 16 pcs EPOC-151VA install at the same Hub site.
System Diagram

3
Power Wattage VS. Cable Distance
Data Rate VS. Cable distance
LED Function table
Name Color Status Function
Pwr Yel l o w On Power is on
Off Power is off
Eth Green Flashing Communication is OK with Traffic
Off No communication
Link Green On Connection is OK; (It takes 10 sec. for LED on)
Off No connection

4
Specification:
* Distance and number of devices supported may be lower due to power supply capacity and wire voltage-drop.
The bandwidth is dynamically allocated (shared based on traffic), and decreases with wire distance.
Phone: [phone] Fax: [phone]
Mail: [e-mail]
ITEM \ MODEL EPoC-151VA EPoC-151PS EPoC-151HP
Ethernet
Connector RJ-45 RJ-45 RJ-45
Connectivity 10/100/1000 Base-T auto-negotiation, auto MDI / MDX crossover
Wire type Cat5 or better
Distance Up to 328 feet (100m)
Cable Link
Connector RJ-45/BNC
Type Receiver (NVR Site) Transmitter (Hub/IP Camera Site)
Wire type Coax, single- or multi-pair UTP, 18/2, or STP wire
Distance Up to 1500 Meters; Please refer to Data Rate VS. Cable distance table
Topology Supports Star, Daisy-Chain, or any combination
Encryption 128-bit AES
Latency 3 ms
Bandwidth500 Mbps Bi-Direction; with dynamic bandwidth allocation
Power
Power Source DC44～56V adapter None None
Power Output - 12W (DC12V/1A) 48W (DC12V/4A)
Physical
Waterproof None None None
Dimensions (mm) 128 x 102 x 36 128 x 102 x 36 128 x 102 x 36
Weight 310g 310g 310g
LEDs
Status indicators
Cable link
Ethernet Power
Ethernet link/activity
Cable link
Ethernet Power
Ethernet link/activity
Cable link
Ethernet Power
Ethernet link/activity
Environment
Temperature Operation: 0℃to 50℃/ 14℉to 122℉
Humidity 20% ~ 85% non-condensing
Power consumption ≤ 3W
Transient immunity 20µS x5 3,000A, 6,000V; ESD 20KV, 200pF
1
*