Icom IC-F5400 Series User manual

Page 1/4
Connect an Icom IC-F5400-series
radio to Mimer X-Link
Interface Power Supply
+12VDC / max 0,3A.
Connection
The radio is connected both through the 25Pin connector and
through the external speaker connector.
See wiring diagram on the following page.
Radio setup
Check the settings as described on the next page.
Icom IC-F5400-series A www.lse.se REE

Page 2/4
Speaker Audio
The audio is connected through the external speaker output jack.
This is affected by the volume control on the radios front. The setting
below will inhibit that some one accidently changes the setting on the
front panel.
Set both the Min and Max Audio Level to 15. This will force the
external audio to have a fixed volume level that is accepted by the
X-Link Interface.
Busy
Set the Ext I/O 17 to Busy active Low.
PTT
Set the Ext I/O 19 to EPTT active Low.
Icom IC-F5400-series A www.lse.se REE

Page 3/4
Settings in the X-Link interface
Select the proper settings for Radio A or Radio B depending on your
connection.
•Radio with squelch output for Rx detect
Part of the Configuration software window
Check/adjust the audio levels in both directions in the interface so
that the users hears the X-Link with the same level as when listening
to other radios.
See the X-Link setup manual for details on setting the audio level.
Icom IC-F5400-series A www.lse.se REE

Page 4/4
Connection Cable:
Select the proper configuration below depending on if your radio will
be connected as Radio A or Radio B to the X-Link interface.
Icom IC-F5400-series A www.lse.se REE