ICP DAS USA ZB-2570 User manual

ZB-2570/2571/2570P/2571P Quick Start Guide, Ver. 1.0 Page 1
Quick Start Guide
Become familiar with your ZB-2570/2571/2570P/2571P in minutes!

ZB-2570/2571/2570P/2571P Quick Start Guide, Ver. 1.0 Page 2
1. Quick Start for the ZigBee Converter
1. Before configuring the ZigBee converter, adjust the switch to
the ZBSET position then switch on the power (Figure 1). After
configuration is co plete, adjust the switch to the RUN
position then switch on the power (Figure 2). Be sure to turn
the power off before adjusting the switch.
2. After installing the ZigBee_Configuration_Utility_Ver_3.3, the
executable file can be found at:
Start \ Progra Files \ ICPDAS \ ZigBee_Configuration_Utility_Ver_3
.3
\ ZigBee_Configuration_Utility_Ver_3.3.exe
3. Connect the ZigBee converter using one of the hardware
interfaces (RS-232, RS-485 or Ethernet; the default
configuration interface is RS-232) and execute the utility.
4. When the following screen is displayed:
In the Environ ent Settings section:
1. Choose the language.
2. Choose the odule (ZB-2570/2571/2570P/2571P).
3. Click the Next button.
1
2
3
Figure
2
Figure 1

ZB-2570/2571/2570P/2571P Quick Start Guide, Ver. 1.0 Page 3
5. When the following screen is displayed:
In the Build the Connection section:
1. Select the configuration interface of your ZigBee converter odule.
2. Enter the interface para eters (COM Port nu ber or IP)
3. Click the Connect button.
1
2
3

ZB-2570/2571/2570P/2571P Quick Start Guide, Ver. 1.0 Page 4
6. When the following screen is displayed:
In the Set the Operating Mode section:
1. Select the operating ode that you plan to use for your ZigBee converter
and devices.
2. Click the Set button.
2
1

ZB-2570/2571/2570P/2571P Quick Start Guide, Ver. 1.0 Page 5
7. When the following screen is displayed:
In the Set the Para eters section:
1. Set the ZigBee para eters. After entering the ZigBee para eter settings,
click the Set button.
2. Set the interface para eters, after finishing the interface para eter
settings, click the Set button.
3. Click the OK button.
When the following alert is displayed, it eans that the
configuration has been successful. Click the OK button to
continue the configuration.
When the following alert is displayed, it eans that configuration
is finished. Click the OK button to exit the configuration.
1
2
3

ZB-2570/2571/2570P/2571P Quick Start Guide, Ver. 1.0 Page 6
2. Installing the ardware
1. Adjust the switch to the RUN position then power on the odule.
2. Serial Port - RS-232

ZB-2570/2571/2570P/2571P Quick Start Guide, Ver. 1.0 Page 7
3. Serial Port - RS-485

ZB-2570/2571/2570P/2571P Quick Start Guide, Ver. 1.0 Page 8
4. Ethernet – RJ-45