ICP DAS USA I-7000 Series User manual

P1
I-7000/M-7000 Quick Start
v1.3, Fed. 2020
■Packing List
In addition to this Quick Start, the package includes the following items:
I-7000/M-7000
Plastic Rail
CA-5810/CA-3813
(10 or 13-pin)
DB-1820
(For I-7000/M-7000)
DN-1822
CA-252518D-1
DN-1823
CA-2525015D
DN-8P8C
CA-090910-A
CA-5810 is for I-7017R-A5-G and M-7017R-A5-G
DB-1820 is for I-7018Z-G/S, M-7018Z-G/S and M-7019Z-G/S
DN-1822 and CA-252518D-1 are for I-7018Z-G/S2, M-7018Z-G/S2, and M-7019Z-G/S2
DN-1823 and CA-2525015D are for I-7018Z-G/S3, M-7018Z-G/S3, and M-7019Z-G/S3
DN-8P8C, CA-090910-A, and CA-3813 are for I-7088(D)-G/S and M-7088(D)-G/S
■Technical Support
[email protected]om
http://ftp.icpdas.com/pub/cd/8000cd/napdos/7000/manual/
Default Communication Parameters:
Parameters
Default Values
(In Run mode)
Initial Values
(In INIT mode)
Model
I-7000
M-7000
I-7000/M-7000
Protocol
DCON
Modbus RTU
DCON
Address
01
00
Baud Rate
9600
Parity
N,8,1

P2
1 Switch to Init Mode
Before attempting to configure the module,
ensure that you move the switch to the
“Init” position, or connect the Init pin to the
GND pin and then power on the module to
access the configuration mode.
2 Connect to the PC and the Power Supply
Note: You should only connect a single I-7000/M-7000 module to the
RS-485 bus during the configuration process.
1) Using an RS-232 to RS-485 Converter
2) Using a USB to RS-485 Converter
Power Supply (+24v, GND)
USB
(+Vs, GND)
I-7000/M-7000
RS-485
( Data+, Data- )
I-7561U/tM-7561
INIT
GND
RS-232
Power Supply (+24v, GND)
I-7000/M-7000
(+Vs, GND)
RS-485
( Data+, Data- )
I-7520/tM-7520U

P3
3 Install the DCON Utility Pro
The DCON Utility Pro can be obtained via FTP from the address below
or by scanning the QR code:
http://ftp.icpdas.com/pub/cd/8000cd/napdos/driver/dcon_utility/
4 Set the Communication Parameters
1
2
3
4

P4
5 Search for and Configure the Module
6 Reboot the Module in “Normal”Mode
Set the switch to the “Normal” position (or
disconnect the INIT* to the GND) then reboot
the module to apply the new configuration.
Also, search for the module again to confirm
that the new configuration is correct
and that the module can be detected.
The initial values will be displayed in Init
mode. You can change the settings.
3
4
5
1
2
INIT
GND