ICRealtime ICIP-D1300 User manual

1
ICIP-D1300
Quickstart Guide
Installation/Accessing

2
Index
Dimensions ……………………………………………………………………………………...3
Connections (Structure) ………………………………………………………………………..4
Installation & Focusing …………………………………………………………………………5
Web Operations/Accessing..……………………………………………………………......6-9

3

4
Connections (Structure)
1.X/Y Adjustments: Allows you to maneuver the lens to obtain best viewing angle.
2.Lens: The actual camera lens.
3.Enclosure: The housing for all internal components.
4.DC 12V: Input DC 12V Power Adaptor.
5. Ethernet Port: Connects to a standard Ethernet Cable.

5
Installation
Please follow the steps listed below to install the ICIP-D1300. Please refer the image above for
reference.
Please draw the installation holes in the installation surface and then mark three
expansion bolts holes in the surface. Insert three bolts in the hole and secure firmly.
Please line up the installation holes of the bottom of the pendant mount bracket to the
installation holes in the surface. Then insert the three bolts to the holes of the bottom of
the bracket. Finally fasten the device on the installation surface.
Focusing: To focus, you will notice a Hex or Philips screw at the top/side of the lens.
Unscrew slightly and carefully turn the lens itself left or right, attempting to find a good
placement. Tighten the screw back once you have the lens placed correctly.

6
Web Operation
This series IPC product supports Web access and management via PC/Mac.
Web includes several modules: monitor channel preview, system configuration, alarm
and etc.
Network Connection
Please follow the steps listed below for network connection.
Make sure the IPC has connected to the network properly.
IPC IP address and PC IP address shall be in the same network segment. IPC
default IP address is 192.168.1.108. If there is router, please set the
corresponding gateway and subnet mask.
Login and Logout
Open IE and input IP camera address in the address bar.
For example, if your camera IP is 192.168.1.108, then please input http:// 192.168.1.108
in IE address bar.

7
The login interface is shown as below.
Please input your user name and password.
Default factory name is admin and password is admin.
Note: For security reasons, please modify your password after you first login.
Input your IP address here.
If it is your first time to login, the system may pop up with a warning box to ask you
whether to install a web plugin. Please click OK button and the system will automatically
install the control plugin. If you can’t download the control file, you may need to lower
temporarily Internet Explorer’s security settings as shown below. If using browsers other
then Internet Explorer, check to verify security settings are set to allow the downloading
of plugins.

8
After you logged in, you can see the main window.